OSHA Inspection: JOSE MURAZ-MARTINEZ

Issued

Jul 28, 2015

Abate by

Aug 21, 2015

Penalty

Initial $2,400 · Current $2,400

General-duty citation text

29 CFR 1926.501(b)(13):  Each employee engaged in residential construction activities 6 feet or more above lower levels were not protected by guardrail systems, safety net system, personal fall arrest system, or other approved alternative fall protection system:    (a)Jose Muraz-Martinez at 601 Gaylord St., Denver, CO 80206:  On and before July 20th, 2015, the exposing employer did not ensure that employees were protected from injury, in that, two employees removing and installing shingles on a single-story residential home, with a roof pitch of approximately 7-in-12, were not utilizing a fall protection system.  This condition exposed the employees to a fall of approximately 11 feet.

Issued

Jul 28, 2015

Abate by

Aug 21, 2015

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1926.503(a)(1):  The employer did not provide a training program for each employee who might be exposed to fall hazards:    (a)Jose Muraz-Martinez at 601 Gaylord St., Denver, CO 80206:  On or before July 20th, 2015 the exposing employer did not ensure that each employee engaged in roofing operations was trained to recognize the hazards of working at elevation and trained in the use of fall protection systems.  Employees removing and installing shingles on a single-story residential home, with a roof slope of 7-in-12, did not utilize a fall protection system.  This condition exposed employees to fall hazards of approximately 11 feet.        Abatement Note:  As of January 1, 1998, Subpart M of the 29 CFR 1926 part 1926.502(d) provides that body belts are not acceptable as part of a personal fall arrest system. The use of a body belt in a tethering system or in a restraint system is acceptable and is regulated under 1926.502(e).    Abatement Note: The employer shall assure that each employee has been trained, as necessary, by a competent person qualified in the following areas:    a)     The nature of fall hazards in the work area; b)     The correct procedures for erecting, maintaining, disassembling, and inspecting the fall protection systems to be used; c)     The use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used;  d)     The role of each employee in the safety monitoring system when this system is used; e)     The limitations on the use of mechanical equipment during the performance of roofing work on low-sloped roofs; f)      The correct procedures for the handling and storage of equipment and materials and the erection of overhead protection; and g)     The role of employees in fall protection plans; h)     The standards contained in this subpart.