LYONS, IL —
OSHA Inspection: G&J GENERAL CONTRACTORS, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of G&J GENERAL CONTRACTORS, INC. in 4247 S. JOLIET AVE., LYONS, IL 60534 (NAICS 238160). OSHA activity number 340850643.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- G&J GENERAL CONTRACTORS, INC.
- Site address
- 4247 S. JOLIET AVE.
- City
- LYONS
- State
- IL
- ZIP
- 60534
- Mailing
- 2639 VERMONT ST., BLUE ISLAND, IL 60406
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 6
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.20 B01
- Issued
- Sep 4, 2015
- Abate by
- Oct 1, 2015
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part. a. On or about August 13, 2015 - at the above addressed jobsite, the employer did not initiate and maintain a safety and health program to comply with the regulations of this part, which included but were not limited to employee protection when exposed to fall hazards.
Recent events (1)
- — Z (S) $2000
1926.503 A01
- Issued
- Sep 4, 2015
- Abate by
- Oct 1, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. a. On or about August 13, 2015 - at the above addressed jobsite, employees performing residential roofing operations were not trained to recognize the hazards of falling and the procedures to be followed in order to minimize the hazards, thereby exposing the employees to fall hazards.
Recent events (1)
- — Z (S) $0
1926.20 B02
- Issued
- Sep 4, 2015
- Abate by
- Sep 11, 2015
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers. a. On or about August 13, 2015 - at the above addressed jobsite, an inspection of the jobsite was not performed by a competent person during residential roofing operations, thereby exposing employees to fall hazards.
Recent events (1)
- — Z (S) $2000
1926.501 B13
- Issued
- Sep 4, 2015
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. a. On or about August 13, 2015 - at the above addressed jobsite, employees performing roofing operations, approximately fourteen (14) feet eight (8) inches above the ground, were not protected from falls, thereby exposing employees to fall hazards.
Recent events (1)
- — Z (S) $2800
1926.1053 B01
- Issued
- Sep 4, 2015
- Abate by
- Sep 11, 2015
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. a. On or about August 13, 2015 - at the above addressed jobsite, the portable ladder used for access to the roof did not extend at least three (3) feet above the landing surface, thereby exposing employees to falls.
Recent events (1)
- — Z (S) $2000
More inspections in this industry (NAICS 238160)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340850643.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.