Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: BIMBO BAKERIES USA, INC.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of BIMBO BAKERIES USA, INC. in 1605 SHEARER DRIVE, CARLISLE, PA 17013 (NAICS 311812). OSHA activity number 340953009.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Bimbo Bakeries USA, INC. — free Get an email when a new federal OSHA severe-injury report for Bimbo Bakeries USA, INC. is published. One employer, no account, unsubscribe in one click.
Site address
1605 SHEARER DRIVE
City
CARLISLE
State
PA
ZIP
17013
Mailing
1605 SHEARER DRIVE, CARLISLE, PA 17013
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
311812
Employees
176
Ownership type
A

4 citations on file for this inspection.

1910.178 M05 I

Serious Gravity 1 1 instance 2 exposed
Issued
Jan 20, 2016
Penalty
Initial $2,550 · Current $3,000
29 CFR 1910.178(m)(5)(i): 29 CFR 1910.178(m)(5)(i): When a powered industrial truck is left unattended, load engaging means were not fully lowered:   a) Cool Pack/Box Former - A Toyota electric pallet jack (Model 7BWS10) was observed unattended with its forks raised 52 inches above the floor, on or about October 2, 2015.  No abatement certification or documentation required.
Recent events (2)
  • — I (S) $3000
  • — Z (S) $2550

1910.212 A01

Serious Gravity 1 1 instance 18 exposed
Issued
Jan 20, 2016
Abate by
Feb 16, 2016
Penalty
Initial $2,550 · Current $3,375
29 CFR 1910.212(a)(1): Machine guarding was not provided to protect operator(s) and other employees from hazards such as those created by point of operation, in-going nip points, rotating parts, and/or flying chips and sparks:    a) Sifter Room - Sifters were not guarded exposing employees to being struck-by the rapid movement and agitation of the machine, on or about September 29, 2015.     Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (S) $3375
  • — Z (S) $2550

1910.303 G01

Serious Gravity 5 1 instance 18 exposed
Issued
Jan 20, 2016
Penalty
Initial $3,400 · Current $0 Reduced
29 CFR 1910.303(g)(1): Sufficient access and working space was not provided and maintained about all electric equipment (operating at 600 volts, nominal, or less to ground) to permit ready and safe operation and maintenance of such equipment:    a) Sifter Room - A disconnect switch located behind sifter number 2 and 3 was not readily accessible, the space between the sifters measured approximately 8 inches wide, on or about 9/29/15.    No abatement certification or documentation required.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3400

1910.145 C03

Other-than-serious 1 instance 18 exposed
Issued
Jan 20, 2016
Abate by
Feb 16, 2016
Penalty
Initial $0 · Current $0
29 CFR 1910.145(c)(3): Safety instruction sign(s) were not used where there was a need for general instructions and suggestions relative to safety measure(s):  a) Mix-Fry Area - A safety instruction sign was not used where employees use portable aluminum fryer bridges to work off of and catch/hold equipment parts and tools, on or about September 29, 2015. There was no information regarding the load or capacity limits of the bridge.  Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View Bimbo Bakeries USA, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340953009.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.