OSHA Inspection: OMNI PRECISION

Issued

Nov 19, 2015

Abate by

Dec 2, 2015

Penalty

Initial $2,200 · Current $1,320 Reduced

General-duty citation text

29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:   On or about October 15, 2015, in the shop area, where employees are exposed to hazardous energies when performing service and maintenance on machinery without conducting periodic inspection of the energy control procedures at least annually to ensure the procedure and the requirements of the standard are being followed.

Issued

Nov 19, 2015

Abate by

Nov 25, 2015

Penalty

Initial $3,080 · Current $1,848 Reduced

General-duty citation text

29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s):   On or about October 15, 2015:     a.  In the shop area where employees were exposed to a caught-in hazard when operating an Okuma LB-35 #1 CNC lathe without a point of operation guard.     b.  In the shop area where employees were exposed to a caught-in hazard when operating an Okuma LB-35 #2 CNC lathe without a point of operation guard.     c.  In the shop area where employees were exposed to a caught-in hazard when operating an Okuma LB-45 CNC lathe without a point of operation guard.     d.  In the shop area where employees were exposed to a caught-in hazard when operating an Okuma Crown CNC lathe without a point of operation guard.