ELMIRA, NY —
OSHA Inspection: FERRARIO FORD-LINCOLN
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of FERRARIO FORD-LINCOLN in 2472 CORNING RD., ELMIRA, NY 14903 (NAICS 441110). OSHA activity number 340989268.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FERRARIO FORD-LINCOLN
- Site address
- 2472 CORNING RD.
- City
- ELMIRA
- State
- NY
- ZIP
- 14903
- Mailing
- 2472 CORNING RD., ELMIRA, NY 14903
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 441110
- Employees
- 55
- Ownership type
- A
Citations
1 citation on file for this inspection.
1910.5 A
- Issued
- Nov 6, 2015
- Abate by
- Dec 12, 2015
- Penalty
- Initial $4,500 · Current $3,150 Reduced
General-duty citation text
29 CFR 1910.5(a): Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees. a) 2472 Corning Rd, Elmira, NY 14903- Auto service vehicle lifts, on or about 10/14/15: Employees were working in proximity or under vehicle lifts throughout the facility and were subject to struck by and caught between hazards if the lift should fail. One lift experienced a lift cable failure while in the raised position. Among other methods, feasible and acceptable abatement methods to correct this hazard are: 1.An automotive lift inspection and maintenance program shall be established in accordance with ANSI/ALI ALOIM 2008-Standards for Automotive Lifts-Safety Requirements for Operation, Inspection and Maintenance and the lift manufactures owner's manual for all automotive lift. 2.Annual inspections of automotive lifts shall be conducted and documented by a qualified lift inspector on the manufacturer's approved checklist who possesses the knowledge and meets the minimum standards set forth in ANSI/ALI ALOIM 2008-Standards for Automotive Lifts-Safety Requirements for Operation, Inspection and Maintenance for all automotive lifts. 3.All required automotive lift preventative maintenance and repairs identified during the annual inspections of all automotive lifts by the qualified lift inspector shall be performed prior to placing that lift back in operation.
Recent events (2)
- — I (S) $3150
- — Z (S) $4500
More inspections in this industry (NAICS 441110)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340989268.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.