CANTON, OH —
OSHA Inspection: M.E.B. SYSTEMS, INC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of M.E.B. SYSTEMS, INC in 142 ARLINGTON AVE NW, CANTON, OH 44708 (NAICS 238160). OSHA activity number 340996164.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- M.E.B. SYSTEMS, INC
- Site address
- 142 ARLINGTON AVE NW
- City
- CANTON
- State
- OH
- ZIP
- 44708
- Mailing
- 2257 STATE ROUTE 39 WEST, SUGARCREEK, OH 44681
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 16
- Ownership type
- A
Citations
6 citations on file for this inspection.
1910.178 L01 I
- Issued
- Nov 12, 2015
- Abate by
- Nov 22, 2015
- Penalty
- Initial $2,000 · Current $1,000 Reduced
General-duty citation text
29 CFR 1910.178(l)(1)(i): The employer did not ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l): On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure the operator of the rough terrain forklift, JLG/Gradall G9-43A was competent and allowed the operator to leave the load engaging means raised while the rough terrain forklift was unattended.
Recent events (2)
- — I (S) $1000
- — Z (S) $2000
1926.501 B10
- Issued
- Nov 12, 2015
- Penalty
- Initial $2,000 · Current $1,000 Reduced
General-duty citation text
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system: a. On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure employees working on the lower roof, west section were protected from fall hazards, approximately 22.7 feet, by ensuring a guardrail system, safety net system, personal fall arrest system, or a safety monitoring system was being used. b. On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure an employee working on the upper roof, east section was protected from fall hazards, measured over 25 feet, by ensuring a guardrail system, safety net system, personal fall arrest system, or a safety monitoring system was being used.
Recent events (2)
- — I (S) $1000
- — Z (S) $2000
1926.502 F01
- Issued
- Nov 12, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(f)(1): Warning lines were not erected around all sides of the roof work area: On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure employees working on the lower roof, west section were protected from fall hazards, approximately 22.7 feet, by ensuring a guardrail system, safety net system, personal fall arrest system, or a safety monitoring system was being used. The area did not have any warning line system installed and no form of fall protection utilized.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.502 F01 I
- Issued
- Nov 12, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(f)(1)(i): When no mechanical equipment was being used the warning line was not erected at least 6 feet (1.8m) from the roof edge: On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure employees were protected from fall hazards approximately 22.7 feet, by ensuring a warning line was erected around all sides of the roof work area when using a safety monitor system.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.502 F01 III
- Issued
- Nov 12, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(f)(1)(iii): Points of access, material handling areas, storage areas, and/or hoisting areas were not connected to the work area by an access path formed by two warning lines: On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure the point of access was properly connected to the work area on the lower roof exposing employees to fall hazards approximately 22.7 feet.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.502 F02 II
- Issued
- Nov 12, 2015
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(f)(2)(ii): The rope, wire, or chain was not rigged or supported in such a way that its lowest point (including sag) was not less than 34 inches (0.9 m) from the walking/working surface and its highest point no more than 39 inches (1.0 m) from the walking/working surface. On or about October 16, 2015, at a worksite located at 142 Arlington Ave NW, Canton, OH 44708, during commercial low slope roofing activities the employer did not ensure all warning lines were properly rigged to ensure the lowest point was not less than 34 inches from the walking working surface. The warning line was below 34 inches on the eastern section of the upper roof, the southeastern section of the lower roof near the ladder and in other areas around the roof.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at M.E.B. Systems, INC
View M.E.B. Systems, INC's full OSHA safety record →
More inspections in this industry (NAICS 238160)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340996164.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.