OSHA Inspection: EDUARDO DE LA PAZ-JUAREZ

Issued

2015-12-03 00:00:00

Abate by

2016-01-04 00:00:00

Penalty

Initial $1440.00 · Current $1440.00

General-duty citation text

29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:   At a residential construction site, employees performing framing work were not protected by a protective helmet while working underneath employees that were framing above at higher levels. The employees were exposed to being struck by objects and/or tools falling from a height greater than (18) feet.

Issued

2015-12-03 00:00:00

Abate by

2016-01-04 00:00:00

Penalty

Initial $1440.00 · Current $1440.00

General-duty citation text

29 CFR 1926.304(d): Portable, power-driven circular saw(s) were not equipped with a guard above and below the base plate or shoe:  At a residential construction site, employees performing framing work were using a circular saw with the lower guard wedged in the up position while cutting framing material exposing the employees to amputation hazards.

Issued

2015-12-03 00:00:00

Abate by

2016-01-04 00:00:00

Penalty

Initial $1080.00 · Current $1080.00

General-duty citation text

29 CFR 1926.403(e): All splices and joints and free ends of conductors were not covered with insulation equivalent to that of the conductors or with an insulating device designed for the purpose:  At a residential construction site, employees performing framing work were using a circular saw with a flexible cord that was not repaired by using equivalent insulation exposing the employees to electrical shock hazards.

Issued

2015-12-03 00:00:00

Abate by

2016-01-04 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.404(f)(6): The path to ground from circuits, equipment, or enclosures was not permanent and continuous:   At a residential construction site, employees performing framing work were using an extension cord to supply electrical power to an air compressor and a circular saw cord that was not equipped with a ground pin exposing employees to electrical shock hazards.

Issued

2015-12-03 00:00:00

Abate by

2016-01-04 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws:  At a residential construction site, employees performing framing work utilized an air compressor with a flexible cord that was not provided with strain relief exposing employees to electrical shock hazards.

Issued

2015-12-03 00:00:00

Abate by

2016-01-04 00:00:00

Penalty

Initial $1800.00 · Current $1800.00

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):  At a residential construction site, employees performing framing activities were exposed to an unprotected fall hazard of approximately 18 feet to the ground below.