OSHA Inspection: ROLLHAUS SEATING PRODUCTS INC

Issued

Dec 22, 2015

Penalty

Initial $2,000 · Current $1,400 Reduced

General-duty citation text

29 CFR 1910.36(d)(1): Employee(s) were not able to open an exit route door from the inside at all times without keys, tools, or special knowledge:    (a) Exit Door Next to Office - The exit was barred shut;  on or about 10/28/15.  (b) In the Warehouse  - The exit was barred shut; on or about 10/28/15.

Issued

Dec 22, 2015

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.37(a)(3): Exit route(s) were not kept free and unobstructed:  Upholstery Cutting Area - The emergency exit was blocked by a rack of vinyl and stuffing; on or about 10/28/15.

Issued

Dec 22, 2015

Abate by

Dec 29, 2015

Penalty

Initial $2,000 · Current $1,400 Reduced

General-duty citation text

29 CFR 1910.213(c)(3): Hand-fed ripsaw(s) did not have non kickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator:     (a) In the workshop - A Delta ten inch Unisaw used to cut wood was not guarded with non kick back fingers; on or about 10/28/15.     NOTE:  THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM IN THE ACCORDANCE WITH 29 CFR 1903.19

Issued

Dec 22, 2015

Abate by

Dec 29, 2015

Penalty

Initial $2,800 · Current $0 Reduced

General-duty citation text

29 CFR 1910.213(d)(1): Circular handfed crosscut table saw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut:     (a) In the workshop - A Delta ten inch Unisaw used to cut wood was not guarded; on or about 10/28/15.      NOTE:   IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM, FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $ 1,000.00 AS PER 29 CFR 1903.19.

Issued

Dec 22, 2015

Abate by

Dec 29, 2015

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.213(h)(1): The sides of the lower exposed portion of the blade of radial saw(s) were not guarded to the full diameter of the blade by a device that automatically adjusted itself to the thickness of the stock and remained in contact with the stock being cut to give maximum protection possible for the operation being performed:      (a) In the woodcutting area - The lower portion of a ten inch Delta radial arm saw was not guarded; on or about 10/28/15.      NOTE:   IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM, FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $ 1,000.00 AS PER 29 CFR 1903.19.