Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: BURTON CONSTRUCTION, LLC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of BURTON CONSTRUCTION, LLC. in 704 LOCUST AVENUE, FAIRMONT, WV 26554 (NAICS 238160). OSHA activity number 341078517.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Burton Construction, LLC. — free Get an email when a new federal OSHA severe-injury report for Burton Construction, LLC. is published. One employer, no account, unsubscribe in one click.
Site address
704 LOCUST AVENUE
City
FAIRMONT
State
WV
ZIP
26554
Mailing
38 WILLIAMS STREET, FAIRMONT, WV 26554
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
4
Ownership type
A

5 citations on file for this inspection.

1926.501 B13

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 30, 2015
Abate by
Dec 10, 2015
Penalty
Initial $2,400 · Current $1,200 Reduced
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system.    (a) Fairmont: An employee was working on a 8/12 and 4/12 pitched roof approximately 12 feet from eave to ground, tearing off shingles and cleaning the roof without the use of a fall protection system, as observed on or about November 17, 2015 and times prior.      ABATEMENT CERTIFICATION IS REQUIRED FOR THIS ITEM.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $2400

1926.503 A01

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 30, 2015
Abate by
Dec 24, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  (a) Fairmont:  An employee working from a roof approximately 12 foot from eave to ground had not been trained by the employer on the recognition of the hazards of working from heights or the procedures to be followed to minimize the hazards, as determined on or about November 17, 2015 and times prior.   ABATEMENT CERTIFICATION IS REQUIRED FOR THIS ITEM.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.20 B01

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 30, 2015
Abate by
Dec 24, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.20(b)(1): The employer did not initiate and maintain an safety and health program as may be necessary to comply with the General safety and health provisions covered in 29 CFR 1926.20.  (a) Fairmont: On or about November 17, 2015, at the worksite, a safety and health program had not been initiated and maintained which addressed the following basic elements.  1.  Management Commitment and Leadership A.  Policy statement: goals established, issued, and communicated to employees. B.  Program Reviewed Annually. C.  Participation in safety meetings, inspections; agenda item in meetings. D.  Adequate commitment of resources. E.  Safety rules and procedures incorporated into site operations. F.  Management observations of safety rules.    2.  Assignment of Responsibility     A.  Safety designee on site, knowledgeable, and accountable. B.  Supervisors' (including foremen) safety and health responsibilities understood. C.  Employees adherence to safety rules.    3.  Identification and Control of Hazards A.  Periodic site inspection program involving supervisors. B.  Preventive controls in place (PPE, Maintenance, and Engineering Controls). C.  Action taken to address hazards. D.  Safety Committee, where appropriate. E.  Technical reference materials available.    4.  Training and Education A.  Supervisors receive basic safety and health training. B.  Specialized training taken when needed. C.  Existence of an employee training program, which is ongoing and effective.    5.  Recordkeeping and Hazard Analysis A.  Records maintained of employee illnesses/injuries, and posted.  B.  Supervisors perform incident investigations, determine causes, and propose corrective action. C.  Injuries, near misses, and illnesses are evaluated for trends, similar causes; corrective action initiated.    6.  First Aid and Medical Assistance A.  First aid supplies and medical services available. B.  Employees informed of medical results. C.  Emergency procedures and training, where necessary.    ABATEMENT CERTIFICATION IS REQUIRED FOR THIS ITEM.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1053 B01

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 30, 2015
Penalty
Initial $1,600 · Current $1,200 Reduced
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed.    (a) Fairmont:  An employee was using a 24 foot Werner extension ladder to access a roof to perform roofing activities and did not have the side rails extended at least 3 feet above the eave, as observed on or about November 17, 2015 and times prior.
Recent events (2)
  • — I (S) $1200
  • — Z (S) $1600

1926.1060 A

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 30, 2015
Abate by
Dec 10, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.  (a) Fairmont:  An employee was utilizing a ladder to access the roof and was not provided training to recognize and minimize the associated hazards, as determined on November 17, 2015 and times prior.   ABATEMENT CERTIFICATION IS REQUIRED FOR THIS ITEM.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View Burton Construction, LLC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341078517.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.