MILBANK, SD ·
OSHA Inspection: RUNNING SUPPLY, INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of RUNNING SUPPLY, INC. in 1706 MORNINGSIDE DRIVE, MILBANK, SD 57252 (NAICS 444220). OSHA activity number 341283703.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RUNNING SUPPLY, INC.
- Site address
- 1706 MORNINGSIDE DRIVE
- City
- MILBANK
- State
- SD
- ZIP
- 57252
- Mailing
- 1706 MORNINGSIDE DRIVE, MILBANK, SD 57252
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 444220
- Employees
- 34
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Mar 24, 2016
- Abate by
- Apr 19, 2016
- Penalty
- Initial $4,000 · Current $2,800 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards. (a)Running Supply, Inc. @ 1706 Morningside Drive, Milbank, SD 57252: On or about February 22, 2016, the employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that employees, were directed to access the roof of the store to look for a roof leak. Employees used a 4' x 4' wide 31.5 inches in height, parts basket with the forklift to raise and lower employees from the roof. The basket was not designed to lift personnel. This condition exposed employees to fall hazards. Among other methods, one feasible and acceptable abatement method to correct this hazard is to use a piece of equipment designed to lift personnel to another platform or level equipped with a gate or door for safely entering and exiting as required by ANSI/ITSDF B56.1-2009, Sections 4.17.1 Only operator-up high lift trucks have been designed to lift personnel. If a work platform is used on trucks designed and intended for handling materials, the requirements of paragraphs 4.17.2 and 4.17.3 shall be met for protection of personnel.
Recent events (2)
- · I (S) $2800
- · Z (S) $4000
1910.23 C01
- Issued
- Mar 24, 2016
- Abate by
- Apr 19, 2016
- Penalty
- Initial $4,000 · Current $2,800 Reduced
General-duty citation text
29 CFR 1910.23(c)(1): Open-sided floors or platforms 4 feet or more above adjacent floor or ground levels were not guarded by a standard railing (or the equivalent as specified in paragraph (e)(3) of this section) on all open sides except where there is entrance to a ramp, stairway, or fixed ladder: (a)Running Supply, Inc. @ 1706 Morningside Drive, Milbank, CO 57252: On or about February 22, 2016, the employer did not ensure open-sided floors that were 4 feet or more above ground levels were guarded by a standard railing or the equivalent, in that, employees accessing the roof to check for leaks were not protected from falls. This condition exposed employees to fall hazards of 11 feet.
Recent events (2)
- · I (S) $2800
- · Z (S) $4000
1910.110 F02 II
- Issued
- Mar 24, 2016
- Abate by
- Apr 19, 2016
- Penalty
- Initial $3,000 · Current $2,100 Reduced
General-duty citation text
29 CFR 1910.110(f)(2)(ii): Containers when stored inside shall not be located near exits, stairways, or in areas normally used or intended for the safe exit of people. (a)Running Supply, Inc. @ 1706 Morningside Drive, Milbank, SD 57252: On or about February 22, 2016, the employer did not ensure employees were protected from fire and explosion hazards associated with the storage of 80lb LPG cylinders. The cylinders were stored in close proximity to an exit in the warehouse. The condition exposed employees to fire hazards.
Recent events (2)
- · I (S) $2100
- · Z (S) $3000
1910.178 L02 II
- Issued
- Mar 24, 2016
- Abate by
- Apr 19, 2016
- Penalty
- Initial $3,000 · Current $0 Reduced
General-duty citation text
29 CFR 1910.178(l)(2)(ii): Training shall consist of a combination of formal instruction (e.g., lecture, discussion, interactive computer learning, video tape, written material), practical training (demonstrations performed by the trainer and practical exercises performed by the trainee), and evaluation of the operator's performance in the workplace. (a)Running Supply, Inc. @ 1706 Morningside Drive, Milbank, SD 57252: On or about February 22, 2016, the employer did not certify that the forklift operator had been trained and evaluated as required by 29 CFR 1910.178(l) in the topics as outlined in 29 CFR 1910.178(l)(3). Employees were not effectively evaluated on the Nissan 50 prior to being authorized to operate the forklift. The employer did not have training program content that consisted of a combination of formal instruction and practical exercises performed by the trainee and evaluated by a supervisor who had the knowledge, training, and experience to train operators and evaluate their competence. This condition exposed employees to operational hazards while driving the Nissan 50 forklift. Abatement Note: The certification shall include: (1) The name of the operator; (2) The date of the training; (3) The date of the evaluation; and, (4) The identity of the person(s) performing the training and evaluation.
Recent events (2)
- · I (S) $0
- · Z (S) $3000
More inspections at Running Supply, INC.
View Running Supply, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 444220)
More inspections in SD
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341283703.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.