OSHA Inspection: KILDARRAGH CONSTRUCTION, INC.

Issued

2016-03-11 00:00:00

Abate by

2016-03-17 00:00:00

Penalty

Initial $2800.00 · Current $2100.00 Reduced

General-duty citation text

29 CFR 1926.451(c)(1): Supported scaffolds with a height to base width (including outrigger supports, if used) ratio of more than four to one (4:1) were not restrained from tipping by guying, tying, bracing, or equivalent means, as set forth in subparagraphs (i) - (iii) of this paragraph.    a) Jobsite: The supported tubular welded frame scaffold was not restrained from tipping or falling over by guying, tying, bracing, or equivalent means exposing employees engaged in stucco activities to a scaffold collapse.           Noted on or about 2/27/16

Issued

2016-03-11 00:00:00

Abate by

2016-03-17 00:00:00

Penalty

Initial $2800.00 · Current $2100.00 Reduced

General-duty citation text

29 CFR 1926.451(f)(6): The clearance between scaffolds and power lines were less than 10 feet.        a) Jobsite: A tubular welded frame scaffold was erected in close proximity to an electrical line exposing employees engaged in stucco activities to electrical hazards.     Noted on or about 2/27/16

Issued

2016-03-11 00:00:00

Abate by

2016-03-17 00:00:00

Penalty

Initial $2800.00 · Current $2100.00 Reduced

General-duty citation text

29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.    a) Jobsite - Employees engaged in stucco activities from the third and four and level of a tubular welded frame scaffold were exposed to fall hazards at heights greater than 10 feet without the use of personal fall arrest or guardrail systems.       Noted on or about 2/27/16