MADISON, WI ·
OSHA Inspection: MADISON AUTO TRIM, INC.
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of MADISON AUTO TRIM, INC. in 5331 WAYNE TERRACE, MADISON, WI 53718 (NAICS 811121). OSHA activity number 341343614.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MADISON AUTO TRIM, INC.
- Site address
- 5331 WAYNE TERRACE
- City
- MADISON
- State
- WI
- ZIP
- 53718
- Mailing
- 5331 WAYNE TERRACE, MADISON, WI 53718
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 811121
- Employees
- 15
- Ownership type
- Private (A)
Citations
10 citations on file for this inspection.
1910.134 C01
- Issued
- Jul 6, 2016
- Abate by
- Aug 24, 2016
- Penalty
- Initial $1,200 · Current $600 Reduced
10732270
General-duty citation text
29 CFR 1910.134(c)(1): In any workplace where respirators are necessary to protect the health of the employees or whenever respirators are required by the employer, the employer did not establish and implement a written respiratory protection program with required worksite-specific procedures: On or about March 23, 2016, the employer did not ensure that a written respiratory protection program was established and implemented for those employees required to wear respiratory protection: a. Employee applying undercoating material wore an elastomeric (half mask) respirator with organic vapor cartridges with R95 pre-filters. b. Employee applying spray on bed liner material wore an elastomeric (half mask) respirator with organic vapor cartridges with R95 pre-filters.
Recent events (2)
- · I (S) $600
- · Z (S) $1200
1910.134 D01 III
- Issued
- Jul 6, 2016
- Penalty
- Initial $1,200 · Current $600 Reduced
10732270
General-duty citation text
29 CFR 1910.134(d)(1)(iii): The employer did not identify and evaluate the respiratory hazard(s) in the workplace; including a reasonable estimate of employee exposures to respiratory hazards and identification of the contaminant's chemical state and physical form: On or about March 23, 2016, employee's exposure was not evaluated when they applied undercoating to vehicles and bed lining material.
Recent events (2)
- · I (S) $600
- · Z (S) $1200
1910.242 A
- Issued
- Jul 6, 2016
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1910.242(a): Hand and portable powered tools or equipment were not kept in safe condition: On or about March 23, 2016, the bay 5 wet/dry vacuum electrical power cord strain-release was compromised, causing the internal electrical wires to be exposed.
Recent events (2)
- · I (S) $1400
- · Z (S) $2800
1910.305 B02 I
- Issued
- Jul 6, 2016
- Penalty
- Initial $1,200 · Current $600 Reduced
General-duty citation text
29 CFR 1910.305(b)(2)(i): Pull boxes, junction boxes, and fittings were not provided with covers approved for the purpose: On or about March 23, 2016, a junction box on the spray paint booth did not have a cover, exposing live wires.
Recent events (2)
- · I (S) $600
- · Z (S) $1200
1910.305 E01
- Issued
- Jul 6, 2016
- Abate by
- Aug 24, 2016
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1910.305(e)(1): Cabinets, cutout boxes, fittings, boxes, and panel board enclosures in damp or wet locations were not installed to prevent moisture or water from entering and accumulating within the enclosures: On or about March 23, 2016 the electrical panel in the detailing bay 5 was not rated for a wet/damp location.
Recent events (2)
- · I (S) $1400
- · Z (S) $2800
1910.305 J01 I
- Issued
- Jul 6, 2016
- Abate by
- Aug 3, 2016
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1910.305(j)(1)(i): Fixtures, lampholders, lamps, rosettes, and receptacles located had live parts normally exposed to employee contact: On or about March 23, 2016 employees were exposed to live electrical parts from the light fixtures.
Recent events (2)
- · I (S) $1400
- · Z (S) $2800
1910.305 J01 IV
- Issued
- Jul 6, 2016
- Abate by
- Aug 3, 2016
- Penalty
- Initial $2,000 · Current $0 Reduced
General-duty citation text
29 CFR 1910.305(j)(1)(iv): Fixtures installed in wet or damp locations were not approved for the purpose and were not so constructed or installed that water could not enter or accumulate in wireways, lamp holders or other electrical parts: On or about March 23, 2016, the light fixtures in the detailing bays were not rated for wet/damp location.
Recent events (2)
- · I (S) $0
- · Z (S) $2000
1910.305 J02 IV
- Issued
- Jul 6, 2016
- Penalty
- Initial $2,800 · Current $1,400 Reduced
General-duty citation text
29 CFR 1910.305(j)(2)(iv): A receptacle installed in a wet or damp location was not suitable for the location:(a) On or about March 23, 2016 110VAC electrical receptacles' in the detailing bays were not suitable for wet/damp locations.
Recent events (2)
- · I (S) $1400
- · Z (S) $2800
1910.1200 E01
- Issued
- Jul 6, 2016
- Abate by
- Aug 24, 2016
- Penalty
- Initial $2,000 · Current $1,000 Reduced
2270M149
General-duty citation text
29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which describes how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) will be met: On or about March 23, 2016, a written hazard communication program was not developed or implemented to inform employee of the occupational physical and health hazards of the chemicals in their work area, such as but not limited to: undercoating, spray on bed liner and various detailing chemicals.
Recent events (2)
- · I (S) $1000
- · Z (S) $2000
1910.303 G01
- Issued
- Jul 6, 2016
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.303(g)(1): Sufficient access and working space was not provided and maintained about all electric equipment (operating at 600 volts, nominal, or less to ground) to permit ready and safe operation and maintenance of such equipment: On or about March 23, 2016 the main building electrical disconnect had sheets of plywood leaning against it.
Recent events (2)
- · I (O) $0
- · Z (O) $0
More inspections in this industry (NAICS 811121)
More inspections in WI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 341343614.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.