GULF SHORES, AL —
OSHA Inspection: MARCOS MARTINEZ
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MARCOS MARTINEZ in 7027 ROCKY ROAD LOOP LOT 13, GULF SHORES, AL 36542 (NAICS 238130). OSHA activity number 341396372.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MARCOS MARTINEZ
- Site address
- 7027 ROCKY ROAD LOOP LOT 13
- City
- GULF SHORES
- State
- AL
- ZIP
- 36542
- Mailing
- 12441 HWY 98 LOT 28, FOLEY, AL 36535
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 10
- Ownership type
- A
Citations
3 citations on file for this inspection.
1926.102 A01
- Issued
- Apr 20, 2016
- Abate by
- May 2, 2016
- Penalty
- Initial $1,600 · Current $1,600
General-duty citation text
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents: a) At 7027 Rocky Road Lp. Gulf Shores, Alabama: On or about April 13, 2016 and at times prior; the employer allowed his employees to operate pneumatic nail guns during framing activities without eye protection exposing his employees to struck-by hazards.
Recent events (1)
- — Z (S) $1600
1926.451 B02
- Issued
- Apr 20, 2016
- Abate by
- May 2, 2016
- Penalty
- Initial $1,200 · Current $1,200
General-duty citation text
29 CFR 1926.451(b)(2): Scaffold platforms and walkways were not at least 18 inches wide: a) At 7027 Rocky Road Lp. Gulf Shores, Alabama: On or about April 13, 2016 and at times prior; the employer allowed his employees to work from an elevated walk board and the width of t walk board was eight inches and not 18 inches as required by the regulations.
Recent events (1)
- — Z (S) $1200
1926.501 B13
- Issued
- Apr 20, 2016
- Penalty
- Initial $1,360 · Current $1,360
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): a) At 7027 Rocky Road Lp. Gulf Shores, Alabama: On or about April 13, 2016 and at times prior; the employer allowed his employees to perform framing activities from the roof area of the house without fall protection exposing them to a fall hazard of 9.2 feet to the ground below.
Recent events (1)
- — Z (S) $1360
More inspections at Marcos Martinez
View Marcos Martinez's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341396372.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.