COLUMBUS, OH —
OSHA Inspection: EUDES ELISEO JIMENEZ
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of EUDES ELISEO JIMENEZ in 3958 BRENDHAM BUILDING 25, COLUMBUS, OH 43230 (NAICS 238130). OSHA activity number 341443364.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EUDES ELISEO JIMENEZ
- Site address
- 3958 BRENDHAM BUILDING 25
- City
- COLUMBUS
- State
- OH
- ZIP
- 43230
- Mailing
- 4538 GRIMSBY ROAD, COLUMBUS, OH 43227
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 6
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.403 B02
- Issued
- May 6, 2016
- Abate by
- May 21, 2016
- Penalty
- Initial $2,200 · Current $2,200
General-duty citation text
29 CFR 1926.403(b)(2): Installation and use. Listed, labeled, or certified equipment shall be installed and used in accordance with instructions included in the listing, labeling, or certification. a. The employer was daisy chaining flexible cords from the back of the building where the Homelite generator was located to the front of the building where they were running two Makita circular saws, thereby exposing employees to an electrical hazard.
Recent events (2)
- — I (S) $2200
- — Z (S) $2200
1926.404 F06
- Issued
- May 6, 2016
- Abate by
- May 21, 2016
- Penalty
- Initial $2,200 · Current $0 Reduced
General-duty citation text
29 CFR 1926.404(f)(6): Grounding path. The path to ground from circuits, equipment, and enclosures shall be permanent and continuous. a. The red extension cord plugged into the homelite LR4300 generator was missing the ground pin, thereby exposing employees to electrical hazards. b. The multiport extension was missing the ground pin, thereby exposing employees to electrical hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $2200
1926.405 A02 II I
- Issued
- May 6, 2016
- Abate by
- May 21, 2016
- Penalty
- Initial $2,200 · Current $0 Reduced
General-duty citation text
29 CFR 1926.405(a)(2)(ii)(I): Flexible cords and cables shall be protected from damage. Sharp corners and projections shall be avoided. Flexible cords and cables may pass through doorways or other pinch points, if protection is provided to avoid damage. a. On May 3, 2016, the extension cord was run through a doorway, where it was exposed to a pinch point, thereby exposing employees to an electrical hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $2200
1926.405 G02 IV
- Issued
- May 6, 2016
- Abate by
- May 21, 2016
- Penalty
- Initial $2,200 · Current $0 Reduced
General-duty citation text
29 CFR 1926.405(g)(2)(iv): Strain relief. Flexible cords shall be connected to devices and fittings so that strain relief is provided which will prevent pull from being directly transmitted to joints or terminal screws. a. The orange extension cord used to energize the Makita circular saw on the northwest side of the building was not provided with strain relief, thereby exposing employees to an electrical hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $2200
1926.1053 B04
- Issued
- May 6, 2016
- Penalty
- Initial $1,760 · Current $1,760
General-duty citation text
29 CFR 1926.1053(b)(4): Ladders shall be used only for the purpose for which they were designed. a. On May 3, 2016, an employee was observed standing on the second to the top rung of a step ladder that was marked "danger do not stand at or above this level", thereby exposing the employee to a 5 foot fall hazard. b. On May 3, 2016, an employee was observed working from an eight foot step ladder that was leaned up against the wall of the structure, thereby exposing the employee to a 4 foot fall hazard.
Recent events (2)
- — I (S) $1760
- — Z (S) $1760
1926.1060 A
- Issued
- May 6, 2016
- Abate by
- May 21, 2016
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1060(a): The employer shall provide a training program for each employee using ladders and stairways, as necessary. The program shall enable each employee to recognize hazards related to ladders and stairways, and shall train each employee in the procedures to be followed to minimize these hazards. a. The employer failed to train employees about the proper use of ladders to prevent the potential for using ladders in a manner that they were not designed, thereby exposing employees to a 5 foot fall hazard.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections in this industry (NAICS 238130)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341443364.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.