Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,193,745Inspections Most recent open 2026-08-06 Last loaded 2026-08-10

OSHA Inspection: RICK'S REMODELING

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RICK'S REMODELING in 712 SMITH ST., NEW LONDON, WI 54961 (NAICS 236118). OSHA activity number 341564706.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rick'S Remodeling for free Get an email when a new federal OSHA severe-injury report for Rick'S Remodeling is published. One employer, no account, unsubscribe in one click.
Establishment
RICK'S REMODELING
Site address
712 SMITH ST.
City
NEW LONDON
State
WI
ZIP
54961
Mailing
N3825 CTY. RD. T, NEW LONDON, WI 54961
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
236118
Employees
1
Ownership type
A

5 citations on file for this inspection.

1926.20 B01

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 18, 2016
Abate by
Sep 6, 2016
Penalty
Initial $1,600 · Current $1,600
29 CFR 1926.20(b)(1): The employer did not initiate and maintain an accident prevention program as may be necessary to comply with the General safety and health provisions covered in 29 CFR 1926.20.  a)  On or about June 20, 2016, during roofing work, at a site located at 712 Smith St., New London, WI 54961, the employer had not developed and implemented a safety and health program that provided for frequent and regular inspections of the job site, materials, and equipment.  The employer did not ensure to develop and implement a safety and health program; that employees recognized and followed the proper procedures for fall hazards greater than 6 feet; and the proper use of ladders were used on construction sites.
Recent events (2)
  • · I (S) $1600
  • · Z (S) $1600

1926.501 B13

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 18, 2016
Abate by
Aug 1, 2016
Penalty
Initial $0 · Current $0
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   a)  On or about June 20, 2016, during roofing work at a site located at 712 Smith St, New London, WI 54961, the employer failed to ensure that employees use a fall protection system when exposed to falls approximately 11 feet to the ground on a low slope roof.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.503 A01

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 18, 2016
Abate by
Aug 1, 2016
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a)  On and or about June 20, 2016, during roofing work at a site located at 712 Smith St., New London, WI 54961, the employer did not ensure that each employee engaged in roofing work had been trained in the fall protection systems requirements to identify and implement conventional or personal fall protection systems.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

1926.1053 B01

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Jul 18, 2016
Abate by
Jul 26, 2016
Penalty
Initial $1,600 · Current $0 Reduced
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:   a)  On or about June 20, 2016, during roofing work at a site located at 712 Smith St., New London, WI 54961, the employer did not ensure the silver portable Keller ladder leaning against the house was extended at least 3 feet above the upper landing surface and was secured at the top to prevent displacement.
Recent events (2)
  • · I (S) $0
  • · Z (S) $1600

1926.1060 A

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Jul 18, 2016
Abate by
Aug 1, 2016
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards:  a)  On or about June 20, 2016, during roofing work at a site located at 712 Smith St., New London, WI 54961, the employer did not ensure each employee had been trained on how to use ladders safely, recognize hazards related to setting up the ladder properly, and securing the ladder from displacement.
Recent events (2)
  • · I (S) $0
  • · Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341564706.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.