Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: GR MASONRY WORK, LLC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of GR MASONRY WORK, LLC in 60 ROUTE# 46, MOUNTAIN LAKES, NJ 07046 (NAICS 238140). OSHA activity number 341644243.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch GR Masonry Work, LLC — free Get an email when a new federal OSHA severe-injury report for GR Masonry Work, LLC is published. One employer, no account, unsubscribe in one click.
Site address
60 ROUTE# 46
City
MOUNTAIN LAKES
State
NJ
ZIP
07046
Mailing
889 LAKE STREET APT# 2, NEWARK, NJ 07104
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
10
Ownership type
A

4 citations on file for this inspection.

1926.451 B01

Serious Gravity 10 1 instance 2 exposed
Issued
Jul 29, 2016
Abate by
Aug 24, 2016
Penalty
Initial $2,800 · Current $1,000 Reduced
29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii)    a. 60 Route#46 Mountain Lakes, NJ (Front Facade)    Employees were observed performing masonry (stucco) activities from a welded tubular frame scaffold that was not fully planked between the front uprights and the guardrail supports, thereby exposing employees to fall hazards.       Violation observed on or about 07/15/2016
Recent events (2)
  • — I (S) $1000
  • — Z (S) $2800

1926.451 E01

Serious Gravity 10 1 instance 2 exposed
Issued
Jul 29, 2016
Abate by
Aug 24, 2016
Penalty
Initial $2,800 · Current $1,000 Reduced
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, sturcure, personnel hoist, or similar surface was not used. Crossbraces were used as a means of access.    a. 60 Route#46 Mountain Lakes, NJ (Front Facade)    Safe access and egress to the welded tubular frame scaffold was not provided to the work platform.  Employees were observed egressing a welded tubular frame scaffold work platform using the cross braces and end rails.    Violation observed on or about 07/15/2016
Recent events (2)
  • — I (S) $1000
  • — Z (S) $2800

1926.451 G01

Serious Gravity 10 1 instance 2 exposed
Issued
Jul 29, 2016
Abate by
Aug 24, 2016
Penalty
Initial $2,800 · Current $1,000 Reduced
29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level. Paragraphs (g)(1)(i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold.       a. 60 Route#46 Mountain Lakes, NJ (Front Facade)    Employee observed performing masonry activities in close proximity to an unprotected edge without adequate means of fall protection, thereby was exposed to an approximate 12 ft fall hazard.          Violation observed on or about 07/15/2016
Recent events (2)
  • — I (S) $1000
  • — Z (S) $2800

1926.452 C02

Serious Gravity 10 1 instance 2 exposed
Issued
Jul 29, 2016
Abate by
Aug 24, 2016
Penalty
Initial $2,800 · Current $360 Reduced
29 CFR 1926.452(c)(2): Tubular welded frames and panels were not braced by cross, horizontal, or diagonal braces, or combination thereof, which would have secured vertical members together laterally:    a. 60 Route#46 Mountain Lakes, NJ (Front Facade)       Employees were observed performing masonry (stucco) activities from a three tier, welded tubular frame scaffold that was not cross braced on the inside, which would have secured and squared the vertical members laterally.     Violation observed on or about  07/15/2016
Recent events (2)
  • — I (S) $360
  • — Z (S) $2800

View GR Masonry Work, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341644243.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.