Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: C AND H CONSTRUCTION

Foreign inspection · Safety discipline

On , OSHA opened a foreign safety inspection of C AND H CONSTRUCTION in 1246 INMAN AVE, EDISON, NJ 08820 (NAICS 238140). OSHA activity number 341730414.

Watch C AND H Construction — free Get an email when a new federal OSHA severe-injury report for C AND H Construction is published. One employer, no account, unsubscribe in one click.
Site address
1246 INMAN AVE
City
EDISON
State
NJ
ZIP
08820
Mailing
110 EAST HOLSMAN STREET, PATERSON, NJ 07522
Inspection type
Foreign (L)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
3
Ownership type
A

7 citations on file for this inspection.

1926.451 E01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3803.00 · Current $3803.00
29 CFR 1926.451(e)(1): A safe means of access for scaffold platforms such as portable ladders, or similar surface was not used:   a. 1246 Inman Avenue, Edison N.J. A safe means of access was not provided to employees engaged in stucco activities that were working from a fabricated Frame Scaffold approximately 18 feet above ground level. Employees were observed accessing the scaffold platform by climbing the frame and crossbraces.  Violation observed on or about August 27, 2016
Recent events (1)
  • — Z (S) $3803

1926.451 G01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3803.00 · Current $3803.00
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:  a. 1246 Inman Avenue, Edison,  NJ  Employees engaged in stucco activities was observed working from a fabricated frame scaffold at heights greater than 10 feet above grade and were not protected from falls by use of a guardrail system or a personal fall arrest system.   Violation observed on or about August 27, 2016
Recent events (1)
  • — Z (S) $3803

1926.451 F03

Serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $3803.00 · Current $3803.00
29 CFR 1926.451(f)(3): Scaffolds and scaffold components were not inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity.  (A)  1246 Inman Ave Edison NJ  Scaffolds and scaffold components were not inspected for visible defects such as, but not limited to, missing cross bracing, incomplete decking, safe access  by a competent person as required.  Observed on or about 08/27/2016
Recent events (1)
  • — Z (S) $3803

1926.451 B01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.451(b)(1):  Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports:   a) 1246 Inman Ave, Edison NJ     The working level of a fabricated frame scaffold was not fully planked. The first section of the working level had 4 out of six planks in place and the second section of the working level had 3 out of six planks installed.   Occurred on or about 08/27/2016
Recent events (1)
  • — Z (S) $0

1926.452 C02

Serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.452(c)(2): Fabricated frame scaffold(s) were not properly braced by cross bracing or diagonal braces, or both, to secure vertical members laterally and to align them so that the erected scaffold was plumb, square, and rigid:  (a)    Location:     1246 Inman Ave, Edison NJ         The working section of the fabricated frame scaffold two sections wide and three levels high having place for 12 sets of cross braces had only 7 sets installed.                                Occurred on or about 08/27/2016
Recent events (1)
  • — Z (S) $0

1926.300 B01

Serious Gravity 10 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $3803.00 · Current $3803.00
29 CFR 1926.300(b)(1): When power operated tools are designed to accommodate guards, they were not equipped with such guards when in use:  a) 1246 Inman Ave Edison NJ,  Employees use a 10" Ryobi table saws with the blade guard removed to cut material during stucco operations. Exposing employees to amputation hazards.  Condition occurred on or about 08/27/2016
Recent events (1)
  • — Z (S) $3803

1926.454 A

Serious Gravity 5 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $2716.00 · Current $2716.00
29 CFR 1926.454(a): The employer did not have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards:  a) Location:      The employer did not train employees working on a scaffold on recognizing and eliminating or minimizing the hazards associated with working on the scaffolds as required by this section.  Occurred on or about 8/27/2016
Recent events (1)
  • — Z (S) $2716

View C AND H CONSTRUCTION's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341730414.