OSHA Inspection: LION ROOFING

Issued

Dec 6, 2016

Penalty

Initial $3,741 · Current $1,870 Reduced

General-duty citation text

29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.    Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.    Located throughout a steep residential roof structure, employees were observed installing & removing roofing shingles while not utilizing an adequate fall protection system. Potential fall heights were measured to be greater than 25 feet with a roof pitch of 5 in12.

Issued

Dec 6, 2016

Abate by

Dec 23, 2016

Penalty

Initial $3,741 · Current $1,870 Reduced

General-duty citation text

29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    Located throughout a steep residential roof structure, employees were observed installing and removing roofing shingles without utilizing a fall protection system had not been trained by the employer to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards. Employees were exposed to a potential fall height greater than 25' above the ground below. Roof pitch was measured to be 5 in 12.    In accordance with 29 CFR 1903.19(d), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in addition, documentation demonstrating that abatement is complete must be included with your certification.  This documentation may include, but is not limited to, evidence of the purchase or repair of the equipment, photographic or video evidence, or written records.