MIDLAND, TX —
OSHA Inspection: RENSHAW CONSTRUCTION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of RENSHAW CONSTRUCTION in 2600 MOCKINGBIRD LANE, MIDLAND, TX 79707 (NAICS 238130). OSHA activity number 341869220.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RENSHAW CONSTRUCTION
- Site address
- 2600 MOCKINGBIRD LANE
- City
- MIDLAND
- State
- TX
- ZIP
- 79707
- Mailing
- 6031 76TH STREET, LUBBOCK, TX 79424
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 10
- Ownership type
- A
Citations
9 citations on file for this inspection.
1926.20 B01
- Issued
- Dec 12, 2016
- Abate by
- Jan 9, 2017
- Penalty
- Initial $1,604 · Current $0 Reduced
General-duty citation text
29 CFR 1926.20(b)(1): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part. Employees engaged in framing operations without fall protection were not provided a safety and health program that would enable them to recognize they were exposed to fall hazards in excess of six feet.
Recent events (2)
- — I (O) $0
- — Z (S) $1604
1926.21 B02
- Issued
- Dec 12, 2016
- Abate by
- Jan 9, 2017
- Penalty
- Initial $3,741 · Current $0 Reduced
General-duty citation text
29 CFR 1926.21(b)(2): The employer did not instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to illness or injury: Employer did not ensure employees in framing activities were trained to recognize and avoid unsafe conditions associated with framing work and exposed employees to fall hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $3741
1926.102 A01
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $2,672 · Current $1,603 Reduced
General-duty citation text
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury from physical agents. Employees engaged in framing operations while using a nail gun were exposed to struck-by hazards while operating nail guns without eye protection.
Recent events (2)
- — I (S) $1603.2
- — Z (S) $2672
1926.405 B02
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $2,138 · Current $1,283 Reduced
General-duty citation text
29 CFR 1926.405(b)(2): All pull boxes, junction boxes, and fittings were not provided with covers: The employer did not ensure a junction box energizing hand tools had a faceplate.
Recent events (2)
- — I (S) $1282.8
- — Z (S) $2138
1926.501 B13
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $3,741 · Current $2,245 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b). Employees engaged in framing operations were exposed to fall hazards in excess of six feet.
Recent events (2)
- — I (S) $2244.6
- — Z (S) $3741
1926.503 A01
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $3,741 · Current $0 Reduced
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: Employees had not been trained to recognize hazards related to falls and the procedures to follow that would minimize those hazards while performing framing activities, at a height of over 6 feet, without fall protection.
Recent events (2)
- — I (S) $0
- — Z (S) $3741
1926.1053 B01
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $3,207 · Current $1,924 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: Employees engaged in framing work were exposed to fall hazards while using a ladder that did not extend at least three feet above the roof's landing.
Recent events (2)
- — I (S) $1924.2
- — Z (S) $3207
1926.1053 B16
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $3,207 · Current $0 Reduced
General-duty citation text
29 CFR 1926.1053(b)(16): Portable ladders with structural defects, such as, but not limited to, broken or missing rungs, cleats, or steps, broken or split rails, corroded components, or other faulty or defective components, were not either immediately marked in a manner that readily identifies them as defective, or tagged with "Do Not Use" or similar language, and were not withdrawn from service until repaired: Employees engaged in framing activities were exposed to fall hazards while using a ladder that had a defective component and was not identified as defective.
Recent events (2)
- — I (S) $0
- — Z (S) $3207
1926.1060 A
- Issued
- Dec 12, 2016
- Abate by
- Jan 20, 2017
- Penalty
- Initial $1,604 · Current $0 Reduced
General-duty citation text
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards. Employees engaged in framing work had not been trained to recognize hazards related to ladders and the procedures to follow that would minimize the hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $1604
More inspections at Renshaw Construction
View Renshaw Construction's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341869220.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.