PEARL, MS —
OSHA Inspection: COLEMAN HAMMONS CONSTRUCTION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of COLEMAN HAMMONS CONSTRUCTION in 5181 OLD BRANDON ROAD, PEARL, MS 39208 (NAICS 238350). OSHA activity number 341912947.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- COLEMAN HAMMONS CONSTRUCTION
- Site address
- 5181 OLD BRANDON ROAD
- City
- PEARL
- State
- MS
- ZIP
- 39208
- Mailing
- 5181 OLD BRANDON ROAD, PEARL, MS 39208
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238350
- Employees
- 9
- Ownership type
- A
Citations
4 citations on file for this inspection.
1910.178 L01 I
- Issued
- Mar 13, 2017
- Abate by
- Apr 25, 2017
- Penalty
- Initial $4,780 · Current $3,000 Reduced
General-duty citation text
29 CFR 1910.178(l)(1)(i): The employer shall ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l). (a) Coleman Hammons - On or about November 15, 2016 the employer did not ensure that the industrial truck operator had been trained prior to operating a Caterpillar TH63 Forklift serial no. R-167.
Recent events (3)
- — F (S) $3000
- — C (S) $4780
- — Z (S) $4780
1910.178 Q07
- Issued
- Mar 13, 2017
- Abate by
- Apr 25, 2017
- Penalty
- Initial $2,390 · Current $2,000 Reduced
General-duty citation text
29 CFR 1910.178(q)(7): Industrial trucks shall be examined before being placed in service, and shall not be placed in service if the examination shows any condition adversely affecting the safety of the vehicle. Such examination shall be made at least daily. Where industrial trucks are used on a round-the-clock basis, they shall be examined after each shift. Defects when found shall be immediately reported and corrected. (a) SE Corner of the Concession Stand - On or about November 15, 2016 employees were exposed to a potential fire and electrical shock hazards while operating a forklift with exposed live electrical part such as: fuses and electrical wires. The forklifts electrical control panel wires and fuse box were open and exposed to moisture. This forklift was not removed from service or repaired prior to use.
Recent events (3)
- — F (O) $2000
- — C (S) $2390
- — Z (S) $2390
1926.451 C02 IV
- Issued
- Mar 13, 2017
- Abate by
- Mar 21, 2017
- Penalty
- Initial $5,577 · Current $5,000 Reduced
General-duty citation text
29 CFR 1926.451(c)(2)(iv): Front-end loaders and similar pieces of equipment shall not be used to support scaffold platforms unless they have been specifically designed by the manufacturer for such use. (a) SE Corner of the Concession Stand - On or about November 15, 2016 two employees were exposed to fall, struck-by, and crushing hazards while riding on an pallet used as a scaffold. This pallet was elevated by a Caterpillar TH63 Forklift serial no. R-167. The pallet was not designed by the manufacturer to be used as a platform to transport employees.
Recent events (3)
- — F (O) $5000
- — C (S) $5577
- — Z (S) $5577
1926.451 C02 V
- Issued
- Mar 13, 2017
- Abate by
- Mar 21, 2017
- Penalty
- Initial $55,770 · Current $25,000 Reduced
General-duty citation text
29 CFR 1926.451(c)(2)(v): Fork-lifts shall not be used to support scaffold platforms unless the entire platform is attached to the fork and the fork-lift is not moved horizontally while the platform is occupied. (a) SE Corner of the Concession Stand - On or about November 15, 2016 two employees were exposed to fall, struck-by, and crushing hazards while riding on an platform used as a scaffold. This pallet was elevated by a Caterpillar TH63 Forklift serial no. R-167. The pallet was not attached to the forklift. COLEMAN HAMMONS CONSTRUCTION WAS PREVIOUSLY CITED FOR A VIOLATION OF THIS OCCUPATIONAL SAFETY AND HEALTH STANDARD OR ITS EQUIVALENT STANDARD 29 CFR 1926.451(C)(2)(V) WHICH WAS CONTAINED IN OSHA INSPECTION NUMBER 1083897 CITATION NUMBER 1, ITEM NUMBER 1, ISSUED ON AUGUST 18, 2015 WITH A FINAL ORDER DATE OF SEPTEMBER 9, 2015 WITH RESPECT TO A WORKPLACE LOCATED AT 527 SPRINGRIDGE RD, CLINTON, MS 39056.
Recent events (3)
- — F (R) $25000
- — C (W) $55770
- — Z (W) $55770
More inspections at Coleman Hammons Construction
View Coleman Hammons Construction's full OSHA safety record →
More inspections in this industry (NAICS 238350)
More inspections in MS
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341912947.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.