NAMPA, ID —
OSHA Inspection: COPPERHEAD ELECTRIC
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of COPPERHEAD ELECTRIC in 8100 EAST EXECUTIVE DRIVE, NAMPA, ID 83687 (NAICS 238210). OSHA activity number 342002961.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- COPPERHEAD ELECTRIC
- Site address
- 8100 EAST EXECUTIVE DRIVE
- City
- NAMPA
- State
- ID
- ZIP
- 83687
- Mailing
- 4027 VERA STREET, BOISE, ID 83704
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238210
- Employees
- 4
- Ownership type
- A
Citations
2 citations on file for this inspection.
1926.501 B01
- Issued
- Jan 13, 2017
- Abate by
- Jan 26, 2017
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.501(b)(1): Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems: a) Conveyor dryer: On or about December 30, 2016 and at times prior thereto employees performed electrical installation activities on top of an unprotected walking/working surface without a fall protection system in place. Employees were exposed to a 12 foot fall to the concrete below. Note ) Certification of corrective action is required for this item.
Recent events (1)
- — Z (S) $0
1926.503 A02 III
- Issued
- Jan 13, 2017
- Abate by
- Feb 9, 2017
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(2)(iii): The employer did not assure that each employee had been trained, as necessary, by a competent person qualified in the use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used: a) Conveyor dryer: On or about December 30, 2016 and at times prior thereto employees did not recognize or acknowledge the hazard of working on an unprotected walking/working surface greater than six feet to the lower level, without a fall protection system in place. Employees did not take action to correct or minimize the hazard. b) Conveyor dryer: On or about December 30, 2016 and at times prior thereto employees used a personal fall arrest system for protection from a 12 foot fall hazard. The employer and employees did not recognize or acknowledge the difference between a fall arrest and fall restraint system and the hazards of using the wrong type of a fall protection system. Note) Certification of corrective action is required for this item.
Recent events (1)
- — Z (S) $0
More inspections in this industry (NAICS 238210)
More inspections in ID
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342002961.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.