OSHA Inspection: TRAMONT MANUFACTURING LLC

Issued

2017-08-10 00:00:00

Abate by

2017-08-22 00:00:00

Penalty

Initial $914.00 · Current $914.00

General-duty citation text

29 CFR 1903.19(d)(1): The employer did not submit to the Agency documents demonstrating that abatement is complete for each willful or repeat violation and for any serious violation for which the Agency indicates in the citation that such abatement documentation is required.  (a)  The employer failed to provide documentation to the Agency demonstrating that abatement is completed for the serious violation that was issued by the Agency.

Issued

2017-05-17 00:00:00

Abate by

2017-05-30 00:00:00

Penalty

Initial $4889.00 · Current $4889.00

General-duty citation text

29 CFR 1910.37(a)(3): Exit route(s) were not kept free and unobstructed:  (a)     The exit door on the east side of the welding bays was cordoned off with Caution tape, two concrete exit stair treads were broken and the exit door at the bottom of the same stair well was locked.

Issued

2017-05-17 00:00:00

Abate by

2017-05-30 00:00:00

Penalty

Initial $6519.00 · Current $6519.00

General-duty citation text

29 CFR 1910.134(c)(1): A written respiratory protection program that included the provisions in 29 CFR 1910.134(c)(1)(i) - (ix) with worksite specific procedures was not established and implemented for required respirator use:  (a)     There was no written respiratory protection program implemented for employees such as the welders and the painters that wear air-supplied welding respirators, negative pressure half-mask respirators and loose fitting hood supplied air painting respirators.

Issued

2017-05-17 00:00:00

Abate by

2017-05-30 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.134(e)(1): The employer did not provide a medical evaluation to determine the employee's ability to use a respirator, before the employee was fit tested or required to use the respirator in the workplace:  (a)     The painter using the supplied air respirator (loose-fitting hood) did not have a current medical approval. (b)     The welders using the powered air purifying respirators did not have current medical approvals.   (c)     The welders using the negative pressure respirators did not have current medical approvals.

Issued

2017-05-17 00:00:00

Abate by

2017-05-30 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.304(g)(5): The path to ground from circuits, equipment, and enclosures was not permanent, continuous, and effective:  (a)     The ground conductor pin was broken off of the electrical plug for the cord and plug connected electric hoist used in the large welding bay.

Issued

2017-05-17 00:00:00

Abate by

2017-05-30 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.334(a)(2)(i): Portable cord and plug connected equipment and flexible cord sets (extension cords) were not visually inspected before use on any shift for external defects (such as loose parts, deformed and missing pins, or damage to outer jacket or insulation) and for evidence of possible internal damage (such as pinched or crushed outer jacket):    (a)     In the welding area the damaged electrical extension cord had a taped repair and had not been removed from service.