CUT AND SHOOT, TX —
OSHA Inspection: JOSE SANCHEZ
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of JOSE SANCHEZ in 11925 HWY 105 E., CUT AND SHOOT, TX 77306 (NAICS 238140). OSHA activity number 342132040.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- JOSE SANCHEZ
- Site address
- 11925 HWY 105 E.
- City
- CUT AND SHOOT
- State
- TX
- ZIP
- 77306
- Mailing
- 17114 SPINDLE OAKS DR., CONROE, TX 77385
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238140
- Employees
- 4
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.451 B01
- Issued
- Mar 20, 2017
- Abate by
- Mar 24, 2017
- Penalty
- Initial $2,716 · Current $2,716
General-duty citation text
29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii): On or about February 23, 2017, on the south side of a commercial building where employees were exposed to a fall hazard exceeding 10 feet when applying stucco/paint material from fabricated frame scaffolding without the platform being fully decked between the uprights.
Recent events (1)
- — Z (S) $2716
1926.451 E01
- Issued
- Mar 20, 2017
- Abate by
- Mar 24, 2017
- Penalty
- Initial $3,259 · Current $3,259
General-duty citation text
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used. Crossbraces were used as a means of access. On or about February 23, 2017, on the south side of a commercial building where employees were exposed to a fall hazard when applying stucco/paint material from fabricated frame scaffolding without a ladder or other safe means of access.
Recent events (1)
- — Z (S) $3259
1926.451 G01
- Issued
- Mar 20, 2017
- Abate by
- Mar 24, 2017
- Penalty
- Initial $3,803 · Current $3,803
General-duty citation text
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section: On or about February 23, 2017, on the south side of a commercial building where employees were exposed to a fall hazard exceeding 10 feet when applying stucco/paint material from fabricated frame scaffolding without a fall protection system.
Recent events (1)
- — Z (S) $3803
1926.451 H02 II
- Issued
- Mar 20, 2017
- Abate by
- Mar 24, 2017
- Penalty
- Initial $1,630 · Current $1,630
General-duty citation text
29 CFR 1926.451(h)(2)(ii): A toeboard was not erected along the edge of platforms more than 10 feet (3.1 m) above lower levels for a distance sufficient to protect employees below: On or about February 23, 2017, on the south side of a commercial building where employees were exposed to a struck-by hazard when applying stucco/paint material from fabricated frame scaffolding exceeding ten feet without toeboards installed.
Recent events (1)
- — Z (S) $1630
1926.452 C02
- Issued
- Mar 20, 2017
- Abate by
- Mar 24, 2017
- Penalty
- Initial $3,803 · Current $3,803
General-duty citation text
29 CFR 1926.452(c)(2): Tubular welded frames and panels were not braced by cross, horizontal, or diagonal braces, or combination thereof, which would have secured vertical members together laterally: On or about February 23, 2017, on the south side of a commercial building where employees were exposed to a fall hazard when applying stucco/paint material from fabricated frame scaffolding without securing vertical members by cross, horizontal, or diagonal braces.
Recent events (1)
- — Z (S) $3803
1926.454 A
- Issued
- Mar 20, 2017
- Abate by
- May 4, 2017
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. On or about February 23, 2017, and times prior thereto, at the construction site where the employees were allowed to work form fabricated frame scaffolding without being trained in the recognition of hazards associated with the scaffolding.
Recent events (1)
- — Z (O) $0
More inspections at Jose Sanchez
View Jose Sanchez's full OSHA safety record →
More inspections in this industry (NAICS 238140)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342132040.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.