OSHA Inspection: REGAL RENOVATORS INC.

Issued

Mar 15, 2017

Abate by

Mar 21, 2017

Penalty

Initial $2,716 · Current $1,670 Reduced

General-duty citation text

29 CFR 1926.451(b)(1): Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii)      a)  Worksite - Employee was exposed to falling while working from the second tier of a fabricated frame scaffold approximately 12ft above the ground.  The scaffold had three planks installed; on or about 3/9/17.    b)  Worksite - Employee was exposed to falling while working from the first tier of a fabricated frame scaffold approximately 6ft above the ground.  The scaffold had two planks installed; on or about 3/9/17.         Note:  The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.

Issued

Mar 15, 2017

Abate by

Mar 21, 2017

Penalty

Initial $2,716 · Current $1,665 Reduced

General-duty citation text

29 CFR 1926.451(e)(1):   When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access.    a)  Worksite - Employees were engaged in stucco application to the exterior of a commercial building while working from a fabricated frame scaffold.  An employee was climbing the crossbraces to gain access to the second tier of the scaffold; on or about 3/9/17.      b)  Worksite - Employees were engaged in stucco application to the exterior of a commercial building while working from a fabricated frame scaffold.  An employee was climbing the cross braces to gain access to the first tier of the scaffold; on or about 3/9/17.            Note:  The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.

Issued

Mar 15, 2017

Abate by

Mar 21, 2017

Penalty

Initial $2,716 · Current $1,665 Reduced

General-duty citation text

29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.      a)  Worksite - Employee was exposed to falling while working from the second tier of a fabricated frame scaffold, approximately 12ft above the ground; on or about 3/9/17.        Note:  The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.

Issued

Mar 15, 2017

Abate by

Apr 10, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which describes how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) will be met (Construction Reference: 1926.59):  a) Worksite, North - Employees applying stucco use materials such as, but not limited to, EIFS Stucco and Waterpoofing products. A written hazard communication program was not in place; on or about 3/9/17.        Note:  The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.       ABATEMENT NOTE:    The written Hazard Communication Program must include descriptions of how the following program elements, required by this regulation, will be developed, implemented, and conveyed to the employer's employee(s) who are exposed to hazardous materials:          a.   Labeling and other forms or warning:               Labels shall include at least the identity of the hazardous            chemical(s), the appropriate hazard warnings, the target organs,            and the name and address of the chemical manufacturer, importer or other responsible party;          b.   A list or inventory of all hazardous materials known to be present in the            workplace must be compiled and be maintained as part of the employer's            written Hazard Communication Program;          c.   Material Safety Data Sheets (MSDSs) for all materials used by            employee(s) in the workplace must be maintained and readily available            all employee(s) on all shifts.          d.   The employer's Hazardous Materials Information and Training Program            must be based upon the employer's written Hazard Communication            Program.  The training for employee(s) must include at least:  Methods and observation that may be used to detect the presence            or release of hazardous chemicals in the work area.                       The physical and health hazards of the chemicals in the work area.               The measures employee(s) can take to protect themselves, such as,            specific procedures, appropriate work practices, emergency            procedures, and personal protective equipment to be used.            The details of the employer's Hazard Communication Program            including an explanation of the labeling systems used, Material            Safety Data Sheets and how employees can obtain and use the            appropriate hazard information;          e.   Methods used to inform employees of the hazards associated with non            routine tasks must also be addressed in the employer's written program;            and          f.   The employer's written Hazard Communication Program must be            made available upon request.          For Multi Employer Work places, the employer's Written Hazard Communication       Program must also specifically address how:          a.   Material Safety Data Sheets for each hazardous material on the job            site will be provided to other employers in the event the other            employer's employee(s) may be exposed to these materials.          b.   The methods the employer will use to inform other employer(s) of            any precautionary measures that need to be taken to protect            employee(s) during normal operating conditions and in foreseeable            emergencies.          c.   The methods the employer will use to inform the other employer(s)            of the labeling system used in the workplace.

Issued

Mar 15, 2017

Abate by

Apr 10, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.1200(g)(8): The employer did not ensure that material safety data sheets were readily accessible to the employees in their work area during each work shift:   a) Worksite - Employees applying stucco use materials such as, but not limited to, EIFS Stucco and Waterproofing.  Safety data sheets were not available; on or about 3/9/17.     Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.

Issued

Mar 15, 2017

Abate by

Apr 10, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.1200(h)(1): Employees were not provided effective information and training on hazardous chemicals in their work area at the time of their initial assignment and whenever a new hazard that the employees had not been previously trained about was introduced into their work area:  a) Worksite - Employees applying stucco use materials such as, but not limited to, EIFS Stucco and Waterproofing. A training program was not in place; on or about 3/9/17.    Note: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.