Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: HAMMONS PRODUCTS

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of HAMMONS PRODUCTS in 414 NORTH STREET, STOCKTON, MO 65785 (NAICS 111335). OSHA activity number 342286291.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Hammons Products for free Get an email when a new federal OSHA severe-injury report for Hammons Products is published. One employer, no account, unsubscribe in one click.
Establishment
HAMMONS PRODUCTS
Site address
414 NORTH STREET
City
STOCKTON
State
MO
ZIP
65785
Mailing
414 NORTH STREET, STOCKTON, MO 65785
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
111335
Employees
69
Ownership type
Private (A)

4 citations on file for this inspection.

1910.28 B15

Deleted Serious Gravity 10 1 instance 2 exposed
Issued
Sep 6, 2017
Abate by
Oct 11, 2017
Penalty
Initial $8,873 · Current $0 Reduced
29 CFR 1910.28(b)(15): Walking-working surfaces not otherwise addressed. Except as provided elsewhere in this section or by other subparts of this part, the employer must ensure each employee on a walking-working surface 4 feet (1.2m) or more above a lower level is protected from falling by: (i) Guardrail systems; (ii) Safety net systems; or (iii) Personal fall protection systems, such as personal fall arrest, travel restraint, or positioning systems.  Employees were exposed to a fall hazard from working at heights of approximately 15-30 feet, employees were required to stand on piles of walnuts stored in Bulk Bin 1 and Bulk Bin 2 as they guided them toward the floor augur system without an approved form of fall protection.
Recent events (2)
  • · I (S) $0
  • · Z (S) $8873

1910.147 C06 I

Other-than-serious 1 instance 1 exposed
Issued
Sep 6, 2017
Abate by
Oct 11, 2017
Penalty
Initial $3,802 · Current $2,281 Reduced
29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:    In that an examination of program elements determined that periodic inspections of energy control procedures were not accomplished and certified.  Specifically, reviews were not conducted to determine if listed steps were still adequate, if any changes had occurred, or if employees had acquired the knowledge needed to effectively isolate energy sources.
Recent events (2)
  • · I (O) $2281.2
  • · Z (S) $3802

1910.219 F03

Serious Gravity 10 1 instance 1 exposed
Issued
Sep 6, 2017
Abate by
Oct 24, 2017
Penalty
Initial $8,873 · Current $5,324 Reduced
29 CFR 1910.219(f)(3):     Sprocket wheels and chains which were seven -7 feet or less above floors or platforms were not enclosed.      Employees in Bulk Bin 1 and Bulk Bin 2, were exposed to a amputation hazard. The exposed sprocket and chain, on the David Brown Radicon gear reducer, located less than 7 feet from the floor which was not enclosed and guarded.
Recent events (2)
  • · I (S) $5323.8
  • · Z (S) $8873

1910.272 G01 II

Serious Gravity 10 1 instance 1 exposed
Issued
Sep 6, 2017
Abate by
Oct 11, 2017
Penalty
Initial $8,873 · Current $5,324 Reduced
29 CFR 1910.272(g)(1)(ii):   All mechanical, electrical, hydraulic, and pneumatic equipment which presents a danger to employees inside grain storage structures was not deenergized and disconnected, locked-out and tagged, blocked-off, or otherwise prevented from operating by other equally effective means or methods.    Employees were exposed to amputation, crushed-by, and struck-by hazards. The employer did not deenergized and disconnected, lock-out, tag or, blocked-off powers sources in storage bins.  Employees were required to work in grain bin while electric auger was powered and operational.
Recent events (2)
  • · I (S) $5323.8
  • · Z (S) $8873

View Hammons Products's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 342286291.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.