OSHA Inspection: D-L FLANGE CORPORATION

Issued

Sep 25, 2017

Abate by

Oct 19, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.178(l)(1)(i): The employer did not ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l):    On or about May 23, 2017 at the facility where employees in the facility were required to operate forklifts without having been trained and evaluated.

Issued

Sep 25, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.178(p)(1): Powered industrial truck(s) found to be in need of repair, defective, or in any way unsafe had not been  taken out of service until restored to safe operating condition(s)    On or about May 23, 2017 throughout the facility where employees were exposed to struck-by hazards while operating Toyota forklifts, SN: 60081, 68183, 63986 and 69361 that were observed to have brake lights, headlights and turn signals that did not work.

Issued

Sep 25, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.184(i)(1): Synthetic web sling(s) were not marked or coded to show rated capacities for each type of hitch and type of synthetic web material:    On or about May 23, 2017 at the facility where employees were exposed to struck-by hazards when using a Hunter synthetic (nylon) web sling SN: 95662-1-1 which had the label torn at the bottom which did not show the rated capacities.

Issued

Sep 25, 2017

Abate by

Sep 29, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    On or about May 23, 2017 at the facility where employees were exposed to a caught-in or between hazard while operating a Bullard vertical cutmaster lathe without proper guarding of rotating parts.

Issued

Sep 25, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.219(c)(3): Vertical or inclined shafting seven -7 feet or less from floor or working platform was not enclosed with stationary casing(s)    On or about May 23, 2017 at the facility where employees were exposed to a struck-by and caught in between hazards when working at Bullard vertical cutmaster machines without guarding the exposed vertical shafting.

Issued

Sep 25, 2017

Abate by

Oct 10, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.:    On or about May 23, 2017 throughout the facility where employees were exposed to injection hazards while blowing off equipment without reducing the air pressure below 30 p.s.i.

Issued

Sep 25, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.305(b)(1)(ii): Unused openings in boxes, cabinets, or fittings were not effectively closed:    On or about May 23, 2017 at the facility where employees were exposed to electrical hazards when using electrical boxes that had unused openings.