COLUMBUS, OH ·
OSHA Inspection: CLAYTON C. LAWSON
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CLAYTON C. LAWSON in 1517 ALUM INDUSTRIAL DRIVE N, COLUMBUS, OH 43209 (NAICS 238160). OSHA activity number 342410974.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CLAYTON C. LAWSON
- Site address
- 1517 ALUM INDUSTRIAL DRIVE N
- City
- COLUMBUS
- State
- OH
- ZIP
- 43209
- Mailing
- 3597 MOTTS PLACE COURT, CANAL WINCHESTER, OH 43110
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 7
- Ownership type
- A
Citations
2 citations on file for this inspection.
1926.501 B10
- Issued
- Jun 29, 2017
- Abate by
- Jul 12, 2017
- Penalty
- Initial $4,183 · Current $4,183
General-duty citation text
29 CFR 1926.501(b)(10): "Roofing work on Low-slope roofs." Except as otherwise provided in paragraph (b) of this section, each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels shall be protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system. Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted. a. Located at 1517 Alum Industrial Drive in Columbus, Ohio: On or about June 20, 2017 and throughout the week prior, employees were performing roofing work on the low sloped roof of the building without an adequate means of fall protection, thereby exposing employees to a fall hazard of approximately eighteen feet. b. Located at 1517 Alum Industrial Drive in Columbus, Ohio: On or about June 20, 2017, employees were using the lower roof at the front of the building to access the upper roof in order to perform roofing work. A means of fall protection was not provided on the lower roof, exposing employees to a fall hazard of approximately eleven feet.
Recent events (1)
- · Z (S) $4183
1926.503 A01
- Issued
- Jun 29, 2017
- Abate by
- Jul 12, 2017
- Penalty
- Initial $4,183 · Current $4,183
General-duty citation text
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. a. Located at 1517 Alum Industrial Drive in Columbus, Ohio: On or about June 20, 2017, the employer failed to provide fall protection training for employees performing roofing work on the building.
Recent events (1)
- · Z (S) $4183
More inspections in this industry (NAICS 238160)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342410974.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.