Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,191,288Inspections Most recent open 2026-07-24 Last loaded 2026-07-29

OSHA Inspection: ASTRO MANUFACTURING & DESIGN, INC.

Referral inspection · Health discipline

On , OSHA opened a referral health inspection of ASTRO MANUFACTURING & DESIGN, INC. in 34459 CURTIS BLVD, EASTLAKE, OH 44095 (NAICS 332710). OSHA activity number 342507639.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Astro Manufacturing & Design, INC. — free Get an email when a new federal OSHA severe-injury report for Astro Manufacturing & Design, INC. is published. One employer, no account, unsubscribe in one click.
Site address
34459 CURTIS BLVD
City
EASTLAKE
State
OH
ZIP
44095
Mailing
34459 CURTIS BLVD, EASTLAKE, OH 44095
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332710
Employees
100
Ownership type
A

7 citations on file for this inspection.

1910.106 E02 IV D

Serious Gravity 5 1 instance 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $3,232 · Current $2,262 Reduced
29 CFR 1910.106(e)(2)(iv)(d): Flammable liquids were not drawn from or transferred into vessels, containers, or portable tanks within a building only through a closed piping system, from safety cans, by means of a device drawing through the top, or from a container or portable tanks by gravity through an approved self-closing valve:  On or about July 28, 2017, the employer failed to ensure that 55 gallon drums used to dispense category 1 flammable liquids via gravity fed transfer had approved self-closing valves.
Recent events (2)
  • — I (S) $2262.4
  • — Z (S) $3232

1910.107 C06

Serious Gravity 5 2 instances 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $3,232 · Current $2,262 Reduced
29 CFR 1910.107(c)(6):  Electrical wiring, motors, and other equipment outside of but within twenty (20) feet of any spraying area, and not separated therefrom by partitions, shall not produce sparks under normal operating conditions and did not otherwise conform to the provisions of subpart S of this part for Class I, Division 2 Hazardous Locations:  On or about July 28, 2017, there was general use electrical equipment/terminals that did not conform to Class I, Division 2 Hazardous Locations on the side of a spray booth; general use electrical terminals were within 3 feet of the open-face of a spray booth.
Recent events (2)
  • — I (S) $2262.4
  • — Z (S) $3232

1910.107 C07

Serious Gravity 5 3 instances 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $3,232 · Current $2,262 Reduced
29 CFR 1910.107(c)(7): Electric lamps outside of but within 20 feet of spraying area(s), and not separated therefrom by partition(s), were not totally enclosed to prevent the falling of hot particles:   On or about July 28, 2017, the electric lamps outside of the spraying areas, but within 20 feet of the spray booths were not enclosed to prevent the falling of hot particles.
Recent events (2)
  • — I (S) $2262.4
  • — Z (S) $3232

1910.107 E02

Serious Gravity 5 1 instance 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $3,232 · Current $2,262 Reduced
29 CFR 1910.107(e)(2): The quantity of flammable liquids or liquids with a flashpoint greater than 199.4 degrees F (93 degrees C) kept in the vicinity of spraying operations were not a minimum required for operations or they exceeded a supply for one day or one shift:   On or about July 28, 2017, the employer failed to ensure that flammable liquids kept in the vicinity of spraying operations did not exceed the required daily use. One the day of the inspection, 7 or more 55 gallon drums and 9 or more 5 gallon buckets (total of 430 gallons or more) of category 1 flammable liquids were kept in the vicinity of the spray booths and not properly stored.
Recent events (2)
  • — I (S) $2262.4
  • — Z (S) $3232

1910.107 G02

Serious Gravity 5 2 instances 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $3,232 · Current $2,262 Reduced
29 CFR 1910.107(g)(2): All spraying areas were not kept as free from the accumulation of deposits of combustible residues as practical, with cleaning conducted daily if necessary:  On or about July 28, 2017, spraying areas were not kept free of combustible deposits. There was overspray on the floors outside of the spray booths and on the exterior of the spray booths, inlcuding on the manometers on the second and third spray booths.
Recent events (2)
  • — I (S) $2262.4
  • — Z (S) $3232

1910.134 G01 I A

Other-than-serious 1 instance 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $0 · Current $0
29 CFR 1910.134(g)(1)(i)(A): Respirators with tight-fitting facepieces were worn by employees who had facial hair that came between the sealing surface of the facepiece and the face or that interfered with valve function:  On or about July 28, 2017, the employer failed to ensure that employees who wear tight-fitting respirators do not have facial hair that interferes with the sealing surface of the face piece.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

1910.134 H02 I

Other-than-serious 1 instance 10 exposed
Issued
Dec 1, 2017
Penalty
Initial $0 · Current $0
29 CFR 1910.134(h)(2)(i): Respirators were not stored to protect them from damage, contamination, dust, sunlight, extreme temperatures, excessive moisture, and damaging chemicals or  were not packed or stored to prevent deformation of the facepiece and exhalation valve:  On or about July 28, 2017, the employer failed to ensure that all respirators were properly stored. A respirator was being stored on painting equipment in a spray booth in the paint room; it was exposed to overspray of paints and flammable liquids.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View Astro Manufacturing & Design, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342507639.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.