CUMMING, GA —
OSHA Inspection: AAA METAL WORKS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of AAA METAL WORKS in 615 LELAND PKWY, CUMMING, GA 30041 (NAICS 238390). OSHA activity number 342554433.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AAA METAL WORKS
- Site address
- 615 LELAND PKWY
- City
- CUMMING
- State
- GA
- ZIP
- 30041
- Mailing
- 165 POAG CROSSING, HIRAM, GA 30141
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238390
- Employees
- 5
- Ownership type
- A
Citations
3 citations on file for this inspection.
1926.100 A
- Issued
- Sep 20, 2017
- Abate by
- Oct 17, 2017
- Penalty
- Initial $3,259 · Current $2,281 Reduced
General-duty citation text
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets: On or about at 8/16/17 located at 615 Leland Pkwy, Cumming, GA: Employees were roofing the back porch on a house with metal roofing, employees were observed swinging material and tools over each others heads and without hard hats exposing them to a struck by hazards.
Recent events (2)
- — I (S) $2281.3
- — Z (S) $3259
1926.501 B13
- Issued
- Sep 20, 2017
- Abate by
- Oct 17, 2017
- Penalty
- Initial $3,803 · Current $2,662 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502: On or about at 8/16/17 located at 615 Leland Pkwy, Cumming, GA: Employees were observed roofing the back porch on a house while working at the edge, the employer did not ensure that fall protection was used by the employees while exposed to fall hazards of approximately up to 21- feet on a low pitch roof.
Recent events (2)
- — I (S) $2662.1
- — Z (S) $3803
1926.1053 B01
- Issued
- Sep 20, 2017
- Abate by
- Oct 17, 2017
- Penalty
- Initial $3,803 · Current $2,662 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: On or about at 8/16/17 located at 615 Leland Pkwy, Cumming, GA: Employees were observed and exposed to fall hazards, while roofing the back porch on a house while the employees were using a portable extension ladder to gain access to the roof, and the ladder was only 16- inches above the landing surface.
Recent events (2)
- — I (S) $2662.1
- — Z (S) $3803
More inspections in this industry (NAICS 238390)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342554433.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.