WINDER, GA ·
OSHA Inspection: FREDY PONCE
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of FREDY PONCE in 1975 TOWNSHIP DRIVE, WINDER, GA 30680 (NAICS 238160). OSHA activity number 342581410.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FREDY PONCE
- Site address
- 1975 TOWNSHIP DRIVE
- City
- WINDER
- State
- GA
- ZIP
- 30680
- Mailing
- 6290 MONICA DRIVE, MORROW, GA 30260
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 2
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.501 B13
- Issued
- Nov 21, 2017
- Abate by
- Dec 18, 2017
- Penalty
- Initial $3,803 · Current $3,803
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): On or about August 23, 2017, at Lot 20b, 1975 Township Drive, Auburn, Georgia: a) Two employees performing roofing work were exposed to a fall hazard of approximately 17-feet and greater when they worked from an approximately 10/12 slope roof without utilizing fall protection. b) An employee performing roofing work was exposed to a fall hazard of approximately 17-feet when he worked from the gables of the house using a carabiner to connect directly to the webbing of a rock climbing harness at the front of his waist. c) An employee performing roofing work was exposed to a fall hazard of approximately 13-feet when he worked from the garage roof of the house without using fall protection.
Recent events (1)
- · Z (S) $3803
1926.1053 B04
- Issued
- Nov 21, 2017
- Abate by
- Dec 18, 2017
- Penalty
- Initial $2,716 · Current $2,716
General-duty citation text
29 CFR 1926.1053(b)(4): Ladder(s) were used for purposes other than the purpose for which they were designed: On or about August 23, 2017, at Lot 20b, 1975 Township Drive, Auburn, Georgia: An employee performing roofing work was exposed to a fall hazard of approximately 17-feet when he and his supervisor used a damaged Werner 28-foot extension ladder with broken rungs at the same time which was designed for single access/egress.
Recent events (1)
- · Z (S) $2716
1926.1053 B05 I
- Issued
- Nov 21, 2017
- Abate by
- Dec 18, 2017
- Penalty
- Initial $2,716 · Current $2,716
General-duty citation text
29 CFR 1926.1053(b)(5)(i): Non-self-supporting ladder(s) were not used at an angle such that the horizontal distance from the top support to the foot of the ladder was approximately one-quarter of the working length of the ladder: On or about August 23, 2017, at Lot 20b, 1975 Township Drive, Auburn, Georgia: a) Two employees performing roofing work were exposed to a fall hazard of approximately 17-feet when they used an aluminum extension ladder that was set with the base of the ladder set approximately 12-feet from top support of the ladder. b) Two employees performing roofing work were exposed to a fall hazard of approximately 10.3-feet when they used an aluminum extension ladder that was set with the base of the ladder set approximately 6-feet from top support of the ladder.
Recent events (1)
- · Z (S) $2716
1926.1053 B16
- Issued
- Nov 21, 2017
- Abate by
- Dec 18, 2017
- Penalty
- Initial $2,716 · Current $2,716
General-duty citation text
29 CFR 1926.1053(b)(16): Portable ladders with structural defects, such as, but not limited to, broken or missing rungs, cleats, or steps, broken or split rails, corroded components, or other faulty or defective components, were not either immediately marked in a manner that readily identifies them as defective, or tagged with "Do Not Use" or similar language, and were not withdrawn from service until repaired. On or about August 23, 2017, at Lot 20b, 1975 Township Drive, Auburn, Georgia: Two employees performing roofing work were exposed to a fall hazard of approximately 17-feet when they used an aluminum extension ladder that was damaged with broken rungs.
Recent events (1)
- · Z (S) $2716
More inspections in this industry (NAICS 238160)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342581410.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.