Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: 100% GOOD CHOICE CONSTRUCTION LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of 100% GOOD CHOICE CONSTRUCTION LLC in 4061 HUDSON HILL DRIVE, HOBART, WI 54155 (NAICS 238160). OSHA activity number 342662897.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch 100% Good Choice Construction LLC — free Get an email when a new federal OSHA severe-injury report for 100% Good Choice Construction LLC is published. One employer, no account, unsubscribe in one click.
Site address
4061 HUDSON HILL DRIVE
City
HOBART
State
WI
ZIP
54155
Mailing
67 RICKY WAY, MENASHA, WI 54952
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
5
Ownership type
A

7 citations on file for this inspection.

1926.20 B02

Deleted Serious Gravity 5 1 instance 5 exposed
Issued
Oct 17, 2017
Abate by
Nov 22, 2017
Penalty
Initial $3,259 · Current $0 Reduced
29 CFR 1926.20(b)(2): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  On September 26, 2017 at 4061 Hudson Hill Drive in Hobart, the employer did not have a program to conduct regular jobsite inspections that would have addressed fall hazards associated with improper setup of roof access/egress extension ladder such as but not limited to improper angle, positioned with top blocked not allowing extension of side rails 3 ft. above roof surface, and ladder not secured.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3259

1926.1053 B01

Serious Gravity 5 1 instance 3 exposed
Issued
Oct 17, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grab rail, shall be provided to assist employees in mounting and dismounting the ladder.  On September 26, 2017 at 4061 Hudson Hill Drive in Hobart, employees were using an extension ladder to gain access to the a single story roof.  The ladder did not extend 3ft. above the roof edge and was not secured to prevent displacement.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1053 B05 I

Serious Gravity 1 1 instance 3 exposed
Issued
Oct 17, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.1053(b)(5)(i): Non-self-supporting ladders shall be used at an angle such that the horizontal distance from the top support to the foot of the ladder is approximately one-quarter of the working length of the ladder (the distance along the ladder between the foot and the top support).  On September 26, 2017 at 4061 Hudson Hill Drive in Hobart, employees were using a extension ladder to  access the roof on a residential house that was not positioned at a 4:1 angle.  The ladder was setup and used with a 2:1 flat angle.  The horizontal distance between the ladder's top support 10.5 ft. and the foot base was 5 ft.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.102 A01

Serious Gravity 1 1 instance 4 exposed
Issued
Oct 17, 2017
Penalty
Initial $1,630 · Current $815 Reduced
29 CFR 1926.102(a)(1): The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.    On or about September 26, 2017 at 4061 Hudson Hill Drive in Hobart, employees operating pneumatic nail guns to install roof shingles without wearing safety glasses.
Recent events (2)
  • — I (S) $815
  • — Z (S) $1630

1926.501 B13

Serious Gravity 10 1 instance 4 exposed
Issued
Oct 17, 2017
Penalty
Initial $3,803 · Current $1,902 Reduced
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure.    On September 26, 2017 at 4061 Hudson Hill Drive in Hobart, employees were working on a roof surface at 19 ft. above surface level without utilizing fall protection equipment.
Recent events (2)
  • — I (S) $1901.5
  • — Z (S) $3803

1926.503 A02 III

Serious Gravity 5 1 instance 5 exposed
Issued
Oct 17, 2017
Abate by
Nov 22, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(2)(iii): The employer shall assure that each employee has been trained, as necessary, by a competent person qualified in the use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used.  On or about September 26, 2017 at 4061 Hudson Hill Drive in Hobart, employees were exposed to fall hazards without receiving adequate training on the use of personal fall arrest equipment.  Employees were not utilizing any fall protection equipment when installing roof shingles at heights greater than 6 feet.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1060 A01 III

Serious Gravity 1 1 instance 3 exposed
Issued
Oct 17, 2017
Abate by
Nov 22, 2017
Penalty
Initial $1,630 · Current $0 Reduced
29 CFR 1926.1060(a)(1)(iii): The employer shall ensure that each employee has been trained by a competent person in the proper construction, use, placement, and care in handling of all stairways and ladders;    On or about September 26, 2017 at 4061 Hudson Hill Drive in Hobart, employees were exposed to fall hazards without receiving adequate training on the installation and use of ladders.  Employees using an extension ladder to access/egress a roof surface with improper angle, positioned with top blocked not allowing extension of side rails 3 ft. above roof surface, and ladder not secured.
Recent events (2)
  • — I (S) $0
  • — Z (S) $1630

View 100% Good Choice Construction LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342662897.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.