SAN ANTONIO, TX —
OSHA Inspection: ARTURO RICO
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ARTURO RICO in 20130 STONE OAK PKWY, SAN ANTONIO, TX 78258 (NAICS 238140). OSHA activity number 342786241.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ARTURO RICO
- Site address
- 20130 STONE OAK PKWY
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78258
- Mailing
- 8312 N. IH 35 APT. 295, AUSTIN, TX 78753
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238140
- Employees
- 2
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.501 B01
- Issued
- Jan 19, 2018
- Abate by
- Feb 5, 2018
- Penalty
- Initial $2,217 · Current $2,217
General-duty citation text
29 CFR 1926.501(b)(1): Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems: On or about November 21, 2017, an employee was exposed to a fall hazard of greater than 6 feet to the ground level below, while applying stucco from a ledge without using fall protection equipment.
Recent events (1)
- — Z (S) $2217
1926.503 A01
- Issued
- Jan 19, 2018
- Abate by
- Feb 5, 2018
- Penalty
- Initial $2,217 · Current $2,217
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee who might be exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: On or about November 21, 2017, an employee was exposed to a fall hazard greater than 6 feet to the ground level below, while applying stucco without being trained to recognize fall hazards.
Recent events (1)
- — Z (S) $2217
1926.1053 B01
- Issued
- Jan 19, 2018
- Abate by
- Feb 5, 2018
- Penalty
- Initial $2,217 · Current $2,217
General-duty citation text
29 CFR 1926.1053(b)(1): Where (a) portable ladder(s) was/were used for access to an upper level landing surface and the ladder's length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigid support that will not deflect, and/or a grasping device was not provided to assist employees in mounting and dismounting the ladder: On or about November 21, 2017, an employee was exposed to a fall hazard, while accessing a landing platform from a Werner portable A-frame ladder without side rails to access a landing platform.
Recent events (1)
- — Z (S) $2217
1926.1053 B04
- Issued
- Jan 19, 2018
- Abate by
- Feb 5, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(4): Ladder(s) were used for purposes other than the purpose for which they were designed: On or about November 21, 2017, an employee was exposed to a fall hazard, while using a Werner portable A-frame ladder to gain access to a landing platform.
Recent events (1)
- — Z (S) $0
1926.1053 B13
- Issued
- Jan 19, 2018
- Abate by
- Feb 5, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(13): The top or top step of a stepladder was used as a step: On or about November 21, 2017, an employee was exposed to a fall hazard, while stepping on the top step of a Werner portable A-frame ladder to access a landing platform.
Recent events (1)
- — Z (S) $0
1926.1060 A
- Issued
- Jan 19, 2018
- Abate by
- Feb 23, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders, to enable each employee to recognize the hazards related to ladders and the procedures to be followed in order to minimize these hazards: On or about November 21, 2017, an employee was exposed to a fall hazard greater than 6 feet to the ground level below, while using a ladder for access without being trained to recognize fall hazards.
Recent events (1)
- — Z (S) $0
More inspections at Arturo Rico
View Arturo Rico's full OSHA safety record →
More inspections in this industry (NAICS 238140)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342786241.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.