SAN ANTONIO, TX —
OSHA Inspection: NARCISO LUGO
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of NARCISO LUGO in 8401 N. NEW BRAUNFELS ST, SAN ANTONIO, TX 78219 (NAICS 238160). OSHA activity number 342803400.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- NARCISO LUGO
- Site address
- 8401 N. NEW BRAUNFELS ST
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78219
- Mailing
- 2122 SILVERADO DR, DALLAS, TX 75253
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 7
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 2, 2018
- Penalty
- Initial $1,663 · Current $1,663
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to an ejection and crushing hazard: On or about November 30, 2017 an employee was exposed to an ejection and crushing hazard, while operating a Genie Forklift, Model # GTH-844, while not utilizing/wearing the required seatbelt.
Recent events (1)
- — Z (S) $1663
1926.501 B13
- Issued
- Feb 2, 2018
- Abate by
- Feb 12, 2018
- Penalty
- Initial $2,217 · Current $2,217
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): Main Building: On or about November 30, 2017, employees were exposed to a fall hazard greater than 6 feet to the level below while re-roofing a low slope roof.
Recent events (1)
- — Z (S) $2217
1926.602 D
- Issued
- Feb 2, 2018
- Abate by
- Feb 12, 2018
- Penalty
- Initial $1,663 · Current $1,663
General-duty citation text
29 CFR 1926.602(d): The employer did not certify that each operator had been trained and evaluated as required by paragraph 29 CFR 1910.178(l): Note: The requirements applicable to construction work under paragraph (d) of this section are identical to those set forth at paragraph (l) of 29 CFR 1910.178. 29 CPR 1910.178(1)(1)(ii) Prior to permitting an employee to operate a powered industrial truck (except for training purposes), the employer did not ensure that each operator has successfully completed the training required by this paragraph (1), except as permitted by paragraph (1)(5), AND AS REFERENCED BY THE NOTE CONTAINED IN 1926.602(d): On or about November 30, 2017, an employee was exposed to a struck by hazard while operating a Genie forklift, Model GTH-844, prior to receiving training and being certified as a competent operator.
Recent events (1)
- — Z (S) $1663
More inspections in this industry (NAICS 238160)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342803400.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.