OSHA Inspection: SELLCO INDUSTRIES, INC.

Issued

Feb 23, 2018

Abate by

May 1, 2018

Penalty

Initial $3,696 · Current $2,218 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish a program consisting of energy control procedures, employee training, and periodic inspections to ensure that before any employee performing any servicing or maintenance on a machine or equipment where the unexpected energizing, start up or release of stored energy could occur and cause injury, the machine or equipment would be isolated from the energy source and rendered inoperative.      a)  Sellco Industries, Inc., on or about 1/30/18:  The employer had not established an energy control program consisting of energy control procedures, employee training and periodic inspections for employees who perform servicing and/or maintenance on various machinery or equipment such as but not limited to: Scybold Paper Cutter; Heat Sealers; Foil Stampers and Screen Printing Presses.

Issued

Feb 23, 2018

Abate by

May 1, 2018

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(5)(i): Locks, tags, chains, wedges, key blocks, adapter pins, self locking fasteners, or other hardware were not provided by the employer for isolating, securing, or blocking of machines or equipment from energy sources:     a)  Throughout the facility, on or about 1/30/18: The employer had not provided any locks, tags or other hardware for isolating, securing or blocking of machines or equipment when servicing and/or maintenance is required on various machinery or equipment such as but not limited to: Scybold Paper Cutter; Heat Sealers; Foil Stampers and Screen Printing Presses.

Issued

Feb 23, 2018

Abate by

May 1, 2018

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(7)(i): The employer did not provide training to ensure that the purpose and function of the energy control program was understood by employees and that employees acquired the knowledge and skills required for the safe application, usage and removal of energy control devices:      a)Throughout the facility, on or about 1/30/18: Training was not provided to employees on the energy control procedures when servicing and/or performing maintenance on various equipment, including but limited to: Scybold Paper Cutter; Heat Sealers; Foil Stampers and Screen Printing Presses.

Issued

Feb 23, 2018

Abate by

Mar 12, 2018

Penalty

Initial $2,956 · Current $1,774 Reduced

General-duty citation text

29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created point of operation, rotating parts, and flying chips:  a)Tab Room, on or about 1/30/18: General International Drill Press was not provided with a chuck and tool guard.  b)Tab Room, on or about 1/30/18: Duracraft 16 Speed Drill Press was not provided with a chuck and tool guard.

Issued

Feb 23, 2018

Abate by

Mar 12, 2018

Penalty

Initial $2,956 · Current $1,774 Reduced

General-duty citation text

29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.:a) Cutting Area, on or about 1/30/18: Employee used compressed air for cleaning purposes was measured at approximately 104.2 p.s.i.