ORANGE, TX —
OSHA Inspection: NSC TECHNOLOGIES
Unprogrammed Related inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Related safety inspection of NSC TECHNOLOGIES in 1403 GREEN AVE SUITE B, ORANGE, TX 77630 (NAICS 561320). OSHA activity number 342946910.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- NSC TECHNOLOGIES
- Site address
- 1403 GREEN AVE SUITE B
- City
- ORANGE
- State
- TX
- ZIP
- 77630
- Mailing
- 500 CRAWFORD ST SUITE 401, PORTSMOUTH, VA 23704
What kind of inspection was it?
- Inspection type
- Unprogrammed Related (G)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 561320
- Employees
- 6
- Ownership type
- A
Citations
2 citations on file for this inspection.
1910.28 B06 I
- Issued
- Jun 7, 2018
- Abate by
- Jul 25, 2018
- Penalty
- Initial $12,934 · Current $7,760 Reduced
General-duty citation text
29 CFR 1910.28(b)(6)(i): Each employee less than 4 feet (1.2 m) above dangerous equipment is protected from falling into or onto the dangerous equipment by a guardrail system or a travel restraint system, unless the equipment is covered or guarded to eliminate the hazard. a) On or about February 8, 2018, at the Akrotex, Inc. Orange Texas Location, the employer did not protect employees from a 5 foot 4 inch fall hazard while feeding film into an Egan Extruder.
Recent events (2)
- — I (S) $7760
- — Z (S) $12934
1910.212 A03 II
- Issued
- Jun 7, 2018
- Abate by
- Jul 25, 2018
- Penalty
- Initial $12,934 · Current $0 Reduced
General-duty citation text
29 CFR 1910.212(a)(3)(ii): Point of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle: a) On or about February 8, 2018, and times prior thereto, the employer did not provide guards to prevent employees that were feeding plastic film into the EGAN extruder from having any part of their body in the danger zone where there were moving and rotating parts.
Recent events (2)
- — I (S) $0
- — Z (S) $12934
More inspections at NSC Technologies
View NSC Technologies's full OSHA safety record →
More inspections in this industry (NAICS 561320)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342946910.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.