OSHA Inspection: DIVERSIFIED MANUFACTURING CORPORATION

Issued

Jul 9, 2018

Abate by

Nov 9, 2018

Penalty

Initial $11,641 · Current $9,312 Reduced

General-duty citation text

OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees are exposed to injuries from inadequately labeled and maintained racking systems:    (a) Racking throughout the facility; On or about February 13, 2018 the employer did not ensure regular inspections for damage of the racking system.    (b) Racking throughout the facility; On or about February 13, 2018 the employer did not display in one or more conspicuous locations a plaque to permanently and prominently display the permissible loading of the rack.    (c) Racking throughout the facility; On or about February 13, 2018 the employer did not ensure that the rack columns were anchored to the floor with anchor bolts adequate to resist all applicable forces.    (d) Racking on East wall of facility; On or about February 13, 2018 the employer did not ensure that the affected areas of damaged racking was immediately isolated.     (e) Racking on East wall of facility; On or about February 13, 2018 the employer did not have a storage rack design professional evaluate the damage, and unload, replace or repair if directed by the professional, any damaged columns, beams, or other structural components to restore the system to at least its original design capacity.    (f) Racking on East wall of facility; On or about February 13, 2018 the employer did not require all pallets to be maintained in good, safe, operating condition, ensure that pallets were properly placed onto pallet load support members in a properly stacked and stable position, and prohibit double-stacking of any pallet position, including the top-most position.    (g) Racking on East wall of facility; On or about February 13, 2018 the employer did not ensure the bottom of all columns were furnished with column base plates.    (i) Racking on East wall of facility; On or about February 13, 2018 the employer did not ensure that the shims were made of a material that meets or exceeds the design bearing strength (LRFD) or allowable bearing strength (ASD) of the floor. The shim size and location under the base plate was not equal to or greater than the required base plate size and location.

Issued

Jul 9, 2018

Penalty

Initial $1,663 · Current $1,330 Reduced

General-duty citation text

29 CFR 1904.41(a)(2): 29 CFR 1904.41(a)(2) Annual electronic submission of OSHA Form 300A Summary of Work-Related Injuries and Illnesses by establishments with 20 or more employees but fewer than 250 employees in designated industries. If your establishment had 20 or more employees but fewer than 250 employees at any time during the previous calendar year, and your establishment is classified in an industry listed in appendix A to subpart E of this part, then you must electronically submit information from OSHA Form 300A Summary of Work-Related Injuries and Illnesses to OSHA or OSHA's designee. You must submit the information once a year, no later than the date listed in paragraph (c) of this section of the year after the calendar year covered by the form.    Located at the Diversified Manufacturing Corporation, 1115 Dexter Street North, Prescott, WI 54021: On or about February, 13, 2018, the employer failed during calendar year 2016, to electronically submit information from their OSHA Form 300A or equivalent by 12/31/2017    a). The establishment employed 110 employees and is classified 333999 during calendar year 2016