RIO GRANDE CITY, TX —
OSHA Inspection: D'MARIA ADULT DAY CARE LLC
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of D'MARIA ADULT DAY CARE LLC in 201 N. FM 3167, SUITE 113-114, RIO GRANDE CITY, TX 78582 (NAICS 624120). OSHA activity number 342978111.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- D'MARIA ADULT DAY CARE LLC
- Site address
- 201 N. FM 3167, SUITE 113-114
- City
- RIO GRANDE CITY
- State
- TX
- ZIP
- 78582
- Mailing
- 201 N. FM 3167, SUITE 113-114, RIO GRANDE CITY, TX 78582
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 624120
- Employees
- 10
- Ownership type
- A
Citations
5 citations on file for this inspection.
1910.303 B07 IV
- Issued
- Jul 2, 2018
- Penalty
- Initial $3,880 · Current $2,500 Reduced
General-duty citation text
29 CFR 1910.303(b)(7)(iv): There shall be no damaged parts that may adversely affect safe operation or mechanical strength of the equipment, such as parts that are broken, bent, cut, or deteriorated by corrosion, chemical action, or overheating: On February 19, 2018, and times prior there to, employees used electrical ranges with damaged parts that adversely affected the safe operation of the equipment in that the transfer switch ends were deteriorated from overheating.
Recent events (2)
- — I (S) $2500
- — Z (S) $3880
1910.305 G02 III
- Issued
- Jul 2, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(g)(2)(iii): Flexible cords and cables were not connected to devices and fittings so that strain relief was provided that would prevent pull from being directly transmitted to joints or terminal screws: On February 27, 2018 and times prior there to, in the Kitchen, employees used a stove range with an energized, 220 volt, single phase, electrical plug fitting, without strain relief.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1910.333 A01
- Issued
- Jul 2, 2018
- Penalty
- Initial $3,880 · Current $2,500 Reduced
General-duty citation text
29 CFR 1910.333(a)(1): The employer failed to ensure that live parts were de-energized before employees began to work on or near live parts: On February 16, 2018, the employer did not establish safety-related work practices consisting of de-energizing live parts to prevent electrical shock and or other injury resulting from direct electrical contact when performing work on circuits which were or could be energized.
Recent events (2)
- — I (S) $2500
- — Z (S) $3880
1910.333 C02
- Issued
- Jul 2, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.333(c)(2): Persons who were not qualified worked on electrical circuit parts or equipment that had not been de-energized under the procedures of paragraph (b) of this section. Such persons were not capable of working safely on energized circuits and were not familiar with the proper use of special precautionary techniques, personal protective equipment, insulating and shielding materials and insulated tools: On February 16, 2018, an unqualified person worked on equipment that had not been de-energized.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1910.332 B02
- Issued
- Jul 2, 2018
- Penalty
- Initial $3,880 · Current $0 Reduced
General-duty citation text
29 CFR 1910.332(b)(2) Additional requirements for unqualified persons. Employees who are covered by paragraph (a) of this section but who are not qualified persons were not trained in and familiar with any electrically related safety practices not specifically addressed by 1910.331 through 1910.335 but which are necessary for their safety: On February 19, 2018, and times prior there to, the employer did not provide training to unqualified persons who worked on energized circuits.
Recent events (2)
- — I (S) $0
- — Z (S) $3880
More inspections in this industry (NAICS 624120)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342978111.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.