Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: SCRANTON CULTURAL CENTER AT THE MASONIC TEMPLE

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of SCRANTON CULTURAL CENTER AT THE MASONIC TEMPLE in 420 NORTH WASHINGTON AVENUE, SCRANTON, PA 18503 (NAICS 711110). OSHA activity number 343040143.

Watch Scranton Cultural Center AT THE Masonic Temple — free Get an email when a new federal OSHA severe-injury report for Scranton Cultural Center AT THE Masonic Temple is published. One employer, no account, unsubscribe in one click.
Site address
420 NORTH WASHINGTON AVENUE
City
SCRANTON
State
PA
ZIP
18503
Mailing
420 NORTH WASHINGTON AVENUE, SCRANTON, PA 18503
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
711110
Employees
25
Ownership type
A

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 18 exposed
Issued
Abate by
Penalty
Initial $3696.00 · Current $3000.00 Reduced
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to falls in excess of ten (10) foot from a mobile scaffold.    a) Facility, 420 North Washington Avenue, Scranton, PA - Employees were elevated on the work platform of a Genie Industries Model PLC-24 Genie Personnel Lift (Serial No. 14-89-19328B) without the lift being stabilized with all four (4) outriggers exposing the employees to a fall hazard of approximately twenty (20) foot above ground level on or about March 26, 2018.    In accordance with 29 CFR 1903.19, abatement certification is required for this violation.
Recent events (3)
  • — F (S) $3000
  • — C (S) $3696
  • — Z (S) $3696

1926.452 W06 II

Serious Gravity 5 1 instance 18 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.452(w)(6)(ii): Employee(s) were allowed to ride on a scaffold that had a height that was more than two times the base width and had not been designed and constructed to meet or exceed nationally recognized stability test requirements.    **NOTE: 29 CFR 1910.27(a): Scaffolds used in general industry did not meet the requirements in 29 CFR part 1926, subpart L (Scaffolds)    Facility, 420 North Washington Avenue, Scranton, PA - Employees on the elevated platform of a Genie Industries Model PLC-24 Genie Personnel Lift (Serial No. 14-89-19328B) were moved while the platform height of 144 inches was greater than four times (>4X) the base width of 29 inches exposing the employees to a fall hazard, on or about March 26, 2018.    In accordance with 1903.19, abatement certification and documentation is required for this violation.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

1926.452 W05

Deleted Serious Gravity 5 1 instance 18 exposed
Issued
Abate by
Penalty
Initial $9239.00 · Current $0.00 Reduced
29 CFR 1926.451(f)(3): Scaffolds and scaffold components were not inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity:    **NOTE: 29 CFR 1910.27(a): Scaffolds used in general industry did not meet the requirements in 29 CFR part 1926, subpart L (Scaffolds)    a) Facility, 420 North Washington Avenue, Scranton, PA - Employees were allowed to work from the platform of a Genie Industries Model PLC-24 Genie Personnel Lift (Serial No. 14-89-19328B) that had not been inspected by a competent person in that the mobile scaffold lacked all four (4) outriggers that were necessary for stability exposing employees to a fall hazard, on or about March 26, 2018.    In accordance with 1903.19, abatement certification and documentation is required for this violation. 29 CFR 1926.452(w)(5): Mobile scaffolds were not stabilized to prevent tipping during movement  **NOTE: 29 CFR 1910.27(a): Scaffolds used in general industry did not meet the requirements in 29 CFR part 1926, subpart L (Scaffolds)  a) Facility, 420 North Washington Avenue, Scranton, PA - Employees on the elevated platform of a Genie Industries Model PLC-24 Genie Personnel Lift (Serial No. 14-89-19328B) were moved while the stabilizing outriggers were not in contact with the ground exposing the employees to a fall hazard, on or about March 26, 2018.  In accordance with 1903.19, abatement certification is required for this violation.
Recent events (3)
  • — F (O) $0
  • — C (S) $0
  • — Z (S) $0

1926.454 A

Other-than-serious 1 instance 18 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.    **NOTE: 29 CFR 1910.27(a): Scaffolds used in general industry did not meet the requirements in 29 CFR part 1926, subpart L (Scaffolds)    a) Facility, 420 North Washington Avenue, Scranton, PA - Employees elevated on a Genie Personnel Lift Model PLC-24 (Serial No. 14-89-19328B) did not recognize the hazards of working from an improperly stabilized lift and/or being moved on the lift and were exposed to fall hazards, on or about March 26, 2018.    In accordance with 1903.19, abatement certification and documentation is required for this violation.
Recent events (3)
  • — F (O) $0
  • — C (S) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343040143.