OSHA Inspection: C & S TOOL & DIE, LLC

Issued

2018-05-11 00:00:00

Abate by

2018-06-07 00:00:00

Penalty

Initial $2956.00 · Current $2069.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:  JOB SITE: 107 East Gate Industrial Blvd., New Haven, MO 63088, on or about 4/4/2018, the employer failed to establish a program consisting of energy control procedures, employee training and periodic inspections for but not limited to the Samsung SL 25ASY CNC Lathe machines.  The workers were exposed to a potential electrical hazards.

Issued

2018-05-11 00:00:00

Abate by

2018-06-07 00:00:00

Penalty

Initial $2217.00 · Current $1552.00 Reduced

General-duty citation text

29 CFR 1910.178(l)(1)(i): The employer did not ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l):  JOB SITE: 107 East Gate industrial Blvd., New Haven, MO 63088, on or about 4/42018, the employer failed to ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation.