Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: J.A. CUSTOM FABRICATORS, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of J.A. CUSTOM FABRICATORS, INC. in 1201 U.S. HIGHWAY 1, NORTH PALM BEACH, FL 33408 (NAICS 238130). OSHA activity number 343068854.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch J.A. Custom Fabricators, INC. — free Get an email when a new federal OSHA severe-injury report for J.A. Custom Fabricators, INC. is published. One employer, no account, unsubscribe in one click.
Site address
1201 U.S. HIGHWAY 1
City
NORTH PALM BEACH
State
FL
ZIP
33408
Mailing
1230 WINGFIELD STREET, LAKE WORTH, FL 33460
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
4
Ownership type
A

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 5 1 instance 3 exposed
Issued
May 3, 2018
Penalty
Initial $3,696 · Current $1,850 Reduced
OSH ACT of 1970 Section (5)(a)(1):  The employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to falls and caught-in-between hazards during the installation of an aluminum frame:    On or about April 5, 2018, at the above addressed work site, the employer did not ensure the operator of the SkyJack Lift followed the manufacturer's recommendation regarding the safe operation of the equipment.
Recent events (2)
  • — I (S) $1850
  • — Z (S) $3696

1926.100 A

Serious Gravity 5 1 instance 3 exposed
Issued
May 3, 2018
Penalty
Initial $2,956 · Current $1,478 Reduced
29 CFR 1926.100(a): Employees were not protected by protective helmets while working in areas where there was a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns:    On or about 4/5/2018, employees were exposed to struck-by hazards while working from vertical and aerial lifts during the installation process of an aluminum frame on an exterior structural wall.
Recent events (2)
  • — I (S) $1478
  • — Z (S) $2956

1926.453 B02 V

Serious Gravity 5 1 instance 1 exposed
Issued
May 3, 2018
Penalty
Initial $3,696 · Current $1,850 Reduced
29 CFR 1926.453(b)(2)(v): A body belt was not worn and/or a lanyard was not attached to the boom or basket when working from an aerial lift:    On or about April 5, 2018, at the above addressed work site, an employee who lacked a means of fall protection was exposed to a fall hazard while operating an aerial lift to hoist an aluminum frame to be installed on an exterior structural wall.
Recent events (2)
  • — I (S) $1850
  • — Z (S) $3696

1926.454 A04

Serious Gravity 5 1 instance 1 exposed
Issued
May 3, 2018
Abate by
Jun 20, 2018
Penalty
Initial $0 · Current $0
29 CFR 1926.454(a)(4): The employer did not train each employee who performs work on a scaffold, by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards, including the maximum intended load and the load-carrying capacity of the scaffolds used:  On or about April 5, 2018, at the above addressed work site, the employer did not ensure adequate training was provided to an employee operating an aerial lift to hoist an aluminum frame to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards, including the maximum intended load and the load-carrying capacity.   PLEASE NOTE: CERTIFICATION OF ABATEMENT IS REQUIRED FOR THIS VIOLATION.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343068854.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.