2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17
Safety Incidents OSHA Severe Injury Reports · 2015–2025

OSHA Inspection: SILVER CUP SCAFFOLDING, I LLC.

Federal Agency inspection · Safety discipline

On , OSHA opened a federal Agency safety inspection of SILVER CUP SCAFFOLDING, I LLC. in 545 EAST 166TH STREET, BRONX, NY 10456 (NAICS 532490). OSHA activity number 343101804.

Watch Silver CUP Scaffolding, I LLC. — free Get an email when a new federal OSHA severe-injury report for Silver CUP Scaffolding, I LLC. is published. One employer, no account, unsubscribe in one click.
Site address
545 EAST 166TH STREET
City
BRONX
State
NY
ZIP
10456
Mailing
29 LORIMER STREET, BROOKLYN, NY 11206
Inspection type
Federal Agency (M)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
532490
Employees
45
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $9054.00 · Current $9054.00
OSH ACT of 1970 Section (5)(a)(1): Each employer shall furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm, in that employees were exposed to struck-by hazards:  On or about April 19, 2018  Location: 8th Floor hoist landing  A) A hoist car was operational while employees were constructing and installing required barrier protection to the sides and above the gates at each floor level. An employee that was tasked to construct and install that protection was struck by the hoist car on the eighth floor when it was being brought down from the ninth floor.  Among other methods, feasible and acceptable abatement methods to correct this hazard include:  1.  Follow the requirements of American National Standard Institute ANSI/ASSE A10.44-2014, "Control of Energy Sources(Lockout/Tagout) for Construction and Demolition Operations" while employees are in areas adjacent to the hoist that are not fully guarded.    2. Follow the requirements of American National Standard Institute ANSI A10.4-1963,  "Safety Requirements for Workmen's Hoists" for guarding of hoist landing areas.  3. Follow the manufacturer's Operation Manual SHE Series 98030718 Rev. 05 Section 2.3.2, "Do Not Stand or Work Beneath the Car"  4. Do not allow employees to operate the construction hoist at or above a landing area that has not been fully protected.    5. Do not allow any employees on any landing area that is not fully protected while the construction hoist is in operation.
Recent events (1)
  • — Z (S) $9054

View SILVER CUP SCAFFOLDING, I LLC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343101804.