Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: DANIEL SANTRAGO

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of DANIEL SANTRAGO in 1246 WEST SAUNDERS RD, DOTHAN, AL 36304 (NAICS 238130). OSHA activity number 343114435.

Watch Daniel Santrago — free Get an email when a new federal OSHA severe-injury report for Daniel Santrago is published. One employer, no account, unsubscribe in one click.
Establishment
DANIEL SANTRAGO
Site address
1246 WEST SAUNDERS RD
City
DOTHAN
State
AL
ZIP
36304
Mailing
206 BRUSHFIRE DRIVE, DOTHAN, AL 36305
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
10
Ownership type
A

3 citations on file for this inspection.

1926.501 B13

Serious Gravity 5 1 instance 4 exposed
Issued
Penalty
Initial $2827.00 · Current $2827.00
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   a) On or about April 24, 2018 at 1246 West Saunders Rd, Dothan: The employer failed to ensure employees blocking rafters in preparation to install sheathing used fall protection which exposed them to fall hazards of 12 feet 5 inches.
Recent events (1)
  • — Z (S) $2827

1926.502 D03

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.502(d)(3): Dee-rings, used as part of a personel fall protection system, did not have a minimum tensil strength of 5000 pounds:  a) On or about April 24, 2018 at 1246 West Saunders Road, Dothan: The employer failed to ensure an employee used the proper Dee ring on his harness to connect his snap hook in that the snap hook was attached to the hammer hold of the tool belt which exposed him to fall hazards of 12 feet 5 inches.
Recent events (1)
  • — Z (S) $0

1926.502 D06 I

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.502(d)(6)(i): A snaphook not of the locking type was engaged (i) directly to webbing, rope or wire rope; (ii) to each other (iii) to a Dee-ring to which another snaphook or other connector is attached;(iv) to a horizontal lifeline; or (v) to any objectwhich is incompatibly shaped or dimensioned in relation to the snaphook such that unintentional disengagement could occur by the connected object being able to depress the snaphook keeper and release itself:  a) On or about April 24, 2018 at 1246 West Saunders Rd, Dothan: The employer did not ensure an employee using personal fall arrest were properly anchored in that his rope was wrapped around a support beam and the snap hook was connected back to the rope while installing bracing on the rafters which exposed them to falls of 12 feet 5 inches.
Recent events (1)
  • — Z (S) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343114435.