OSHA Inspection: MAJORD, LLC

Issued

May 23, 2018

Abate by

Jun 19, 2018

Penalty

Initial $1,413 · Current $848 Reduced

General-duty citation text

29 CFR 1910.22(a)(3): Walking-working surfaces were not maintained free of hazards such as sharp or protruding objects, loose boards, corrosion, leaks, spills, snow, and ice:  a.  180 Industrial Park Circle, Lawrenceville, GA (Shop Area) - Employees were exposed to fall and/or trip hazard. Employees are required to walk in close proximity to the unguarded section of the drainage channel system located on the floor of the shop area where the recycle water drains into. The grates which covers the drainage was missing, exposing an open section area approximately 20ft. long x 2ft. deep x 8ft. wide, where an employee can accidentally trip and fall when walking in close proximity to the area, on or about  May 01, 2018.    b.  180 Industrial Park Circle, Lawrenceville, GA (Shop Area) - Employees were exposed to fall hazard.  Employees are required to walk and work in close proximity to the unguarded collected recycle water pit approximately 2'8" deep x 3ft wide, exposing employees to trip and/or fall when walking and/or working in close proximity to the unguarded pit, on or about May 01, 2018.

Issued

May 23, 2018

Abate by

Jun 19, 2018

Penalty

Initial $1,413 · Current $848 Reduced

General-duty citation text

29 CFR 1910.37(b) (2): Each exit was not clearly visible and marked by a sign reading "Exit":  a. 180 Industrial Park Circle, Lawrenceville, GA (Shop Area) - Employees were exposed to fire hazard.  The designated emergency exit doors were not marked and/or identified as to its use.  The emergency exit was not displayed with the sign indicating "EXIT" above the door which is designated as an emergency exit door, on or about May 01, 2018.

Issued

May 23, 2018

Abate by

Jun 19, 2018

Penalty

Initial $1,413 · Current $848 Reduced

General-duty citation text

29 CFR 1910.243(a)(1)(i): Portable power driven circular saw(s) having a blade diameter greater than two inches were not equipped with guard(s) below the base plate or shoe which automatically and instantly returned to the covering position when the tool was withdrawn from the work:  a.  180 Industrial Park Circle, Lawrenceville, GA (Fabrication Area) - Employees were exposed to flying debris and struck-by hazard.  Employees are required to operate the hand Makita grinder with a 6" circular blade to cut holes on the granite where the sink will be installed. The grinder guard was removed and/or missing, exposing employees to flying particles and struck by hazard by the rotating blade, on or about May 01, 2018.