FORT STOCKTON, TX —
OSHA Inspection: ANJO CONSTRUCTION
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of ANJO CONSTRUCTION in 2792 N. HWY 18 BURGER KING, FORT STOCKTON, TX 79735 (NAICS 238130). OSHA activity number 343156105.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ANJO CONSTRUCTION
- Site address
- 2792 N. HWY 18 BURGER KING
- City
- FORT STOCKTON
- State
- TX
- ZIP
- 79735
- Mailing
- 14042 N. RICE, GARDENDALE, TX 79758
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 3
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.453 B02 V
- Issued
- Sep 27, 2018
- Abate by
- Nov 1, 2018
- Penalty
- Initial $2,217 · Current $1,340 Reduced
General-duty citation text
29 CFR 1926.453(b)(2)(v): A safety harness with lanyard attached to the boom or basket was not worn by employee(s) working from an aerial lift: On or about May 10, 2018, an employee was working on an aerial lift without wearing a body belt or lanyard attached to the basket. The employee was exposed to fall hazards greater than ten feet to the ground below.
Recent events (2)
- — I (S) $1340
- — Z (S) $2217
1926.501 B10
- Issued
- Sep 27, 2018
- Abate by
- Nov 1, 2018
- Penalty
- Initial $2,217 · Current $1,330 Reduced
General-duty citation text
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems or a combination of warning line system and safety monitoring system: On or about May 10, 2018, employees were working on the roof of a building without any form of fall protection. The employees were exposed to fall hazards of greater than six feet to the ground below.
Recent events (2)
- — I (S) $1330
- — Z (S) $2217
1926.503 A01
- Issued
- Sep 27, 2018
- Abate by
- Nov 1, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: On or about May 10, 2018, the employer did not provide a fall protection training program to employees. Employees were exposed to fall hazards of more than six feet.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.1053 B01
- Issued
- Sep 27, 2018
- Abate by
- Nov 1, 2018
- Penalty
- Initial $2,217 · Current $1,330 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): Portable ladders were used for access to an upper landing surface and the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface to which the ladder was used to gain access: On or about May 10, 2018, employees were working on the roof of a commercial building using a portable ladder to access the roof but the side rails of the ladder were not at least three feet above the landing. The employees were exposed to fall hazards of greater than six feet to the ground below.
Recent events (2)
- — I (S) $1330
- — Z (S) $2217
1926.1053 B04
- Issued
- Sep 27, 2018
- Abate by
- Nov 1, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.1053(b)(4): Ladders were used for purposes other than the purpose for which they were designed: On or about May 10, 2018, employees were using a step ladder as an extension ladder to access a higher lever of the building. This condition exposed employees to fall hazards.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at Anjo Construction
View Anjo Construction's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343156105.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.