Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: SAN MIGUEL CONSTRUCTION AND REMODELING, LLC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SAN MIGUEL CONSTRUCTION AND REMODELING, LLC. in 7250 GOODLEAF WAY, BATON ROUGE, LA 70806 (NAICS 238130). OSHA activity number 343253431.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch SAN Miguel Construction and Remodeling, LLC. — free Get an email when a new federal OSHA severe-injury report for SAN Miguel Construction and Remodeling, LLC. is published. One employer, no account, unsubscribe in one click.
Site address
7250 GOODLEAF WAY
City
BATON ROUGE
State
LA
ZIP
70806
Mailing
20344 TUCANY COURT, LIVINGSTON, LA 70754
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
6
Ownership type
A

5 citations on file for this inspection.

1926.102 A01

Serious Gravity 5 1 instance 2 exposed
Issued
Oct 22, 2018
Abate by
Nov 1, 2018
Penalty
Initial $2,217 · Current $2,217
29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles.:  On or about June 28, 2018, at 7250 Goodleaf Way, Baton Rouge, LA, an employee was conducting framing work on a residential home using nails guns without eye protection.
Recent events (1)
  • — Z (S) $2217

1926.451 G01 VII

Serious Gravity 5 1 instance 1 exposed
Issued
Oct 22, 2018
Abate by
Nov 1, 2018
Penalty
Initial $2,772 · Current $2,772
29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section:  On or about August 26, 2018, at 7250 Goof Leaf Way, Baton Rouge, LA, an employee was conducting framing work on a roof at a height of approximately 20 feet without a means of fall protection while standing on a job mad scaffold.
Recent events (1)
  • — Z (S) $2772

1926.501 B11

Serious Gravity 5 1 instance 6 exposed
Issued
Oct 22, 2018
Abate by
Nov 1, 2018
Penalty
Initial $2,772 · Current $2,772
29 CFR 1926.501(b)(11): Each employee on a steep roof with unprotected sides and edges 6 feet (1.8 m) or more above lower levels was not protected from falling by guardrail systems with toeboards, safety net systems, or personal fall arrest systems:  On or about June 26,2018, at 7250 Good Leaf way, Baton Rouge, LA, employees were conducting framing work on a residential home at a height of approximately 20 feet without a means of fall protection.
Recent events (1)
  • — Z (S) $2772

1926.1053 B01

Serious Gravity 1 1 instance 2 exposed
Issued
Oct 22, 2018
Abate by
Nov 1, 2018
Penalty
Initial $1,663 · Current $1,663
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  On or about June 26, 2018, at 7250 Good Leaf Way, Baton Rouge, LA, the employer failed to ensure the ladder employees used to access and egress a roof extended 3 feet above the landing surface.
Recent events (1)
  • — Z (S) $1663

1926.416 E01

Other-than-serious 1 instance 1 exposed
Issued
Oct 22, 2018
Abate by
Nov 1, 2018
Penalty
Initial $0 · Current $0
29 CFR 1926.416(e)(1): Worn or frayed electric cords or cables shall not be used:  On or about June 28, 2018, at 7250 Good Leaf Way, Baton Rouge, LA, an employee was using a portable circular saw with a damage cord to cut framing plywood at the work site.
Recent events (1)
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343253431.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.