SYRACUSE, NY ·
OSHA Inspection: DEKAT CONSTRUCTION, INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of DEKAT CONSTRUCTION, INC. in 142-144 MATHER STREET, SYRACUSE, NY 13203 (NAICS 238160). OSHA activity number 343268975.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- DEKAT CONSTRUCTION, INC.
- Site address
- 142-144 MATHER STREET
- City
- SYRACUSE
- State
- NY
- ZIP
- 13203
- Mailing
- 1910 WHITESBORO STREET, UTICA, NY 13502
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 5
- Ownership type
- Private (A)
Citations
5 citations on file for this inspection.
1926.100 A
- Issued
- Jul 11, 2018
- Penalty
- Initial $2,217 · Current $2,217
General-duty citation text
29 CFR 1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets: a) On or about 6/29/2018, 142-144 Mather Street: An employee performing ground work was not wearing a hard hat while roofing work was being conducted above him.
Recent events (1)
- · Z (S) $2217
1926.404 B01 II
- Issued
- Jul 11, 2018
- Abate by
- Jul 23, 2018
- Penalty
- Initial $1,663 · Current $1,663
General-duty citation text
29 CFR 1926.404(b)(1)(ii): On a construction site, where an assured equipment grounding program was not utilized, all 120-volt, single-phase, 15 and 20 ampere receptacle outlets which were not a part of the permanent wiring of the building or structure and which are in use by employees did not have approved ground fault circuit interrupers for personal protection: a) On or about 6/29/2018, 142-144 Mather Street: An employee was utilizing a Makita circular saw energized through an extension cord. No Ground Fault Circuit Interrupter (GFCI) was in use. Abatement certification is required for this item.
Recent events (1)
- · Z (S) $1663
1926.501 B13
- Issued
- Jul 11, 2018
- Penalty
- Initial $3,880 · Current $3,880
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): a) On or about 6/29/2018, 142-144 Mather Street: Employees performing roofing work on a two family residence with an eave to ground height of over 20 feet with a roof pitch of approximately 10:12, were not utilizing any fall protection. This exposed employees to falls of over 20 feet from the eaves and over 26 feet from the peak.
Recent events (1)
- · Z (S) $3880
1926.503 A01
- Issued
- Jul 11, 2018
- Abate by
- Aug 6, 2018
- Penalty
- Initial $2,772 · Current $2,772
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: a) On or about 6/29/2018, 142-144 Mather Street: Employees performing roofing work on a two family residence with an eave to ground height of over 20 feet with a roof pitch of approximately 10:12, were not provided with training regarding the proper use of personal fall arrest systems. Including, but not limited to the proper installation of anchorages, donning and doffing of harnesses, maintenance of ropes, use of rope grabs, and fall protection limitations. Abatement certification is required for this item.
Recent events (1)
- · Z (S) $2772
1926.1053 B01
- Issued
- Jul 11, 2018
- Abate by
- Jul 23, 2018
- Penalty
- Initial $2,772 · Current $2,772
General-duty citation text
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: a) On or about 6/29/2018, 142-144 Mather Street: Employees performing roofing work on a two family residence with an eave to ground height of over 20 feet were accessing the roof utilizing a portable extension ladder which did not extend three feet past the eave of the roof. Abatement certification is required for this item.
Recent events (1)
- · Z (S) $2772
More inspections in this industry (NAICS 238160)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 343268975.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.