Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: SAMUEL AND MARIA LLANO FALCON CONSTRUCTION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SAMUEL AND MARIA LLANO FALCON CONSTRUCTION in 5290 SNOW VALLEY LN, LIBERTY TOWNSHIP, OH 45044 (NAICS 238170). OSHA activity number 343304721.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Samuel and Maria Llano Falcon Construction — free Get an email when a new federal OSHA severe-injury report for Samuel and Maria Llano Falcon Construction is published. One employer, no account, unsubscribe in one click.
Site address
5290 SNOW VALLEY LN
City
LIBERTY TOWNSHIP
State
OH
ZIP
45044
Mailing
273 LISCUM DR., DAYTON, OH 45417
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238170
Employees
4
Ownership type
A

3 citations on file for this inspection.

1926.20 B02

Repeat Gravity 10 1 instance 4 exposed
Issued
Nov 14, 2018
Abate by
Dec 11, 2018
Penalty
Initial $8,536 · Current $8,536
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  The employer fails to provide fall protection for employees engaged in residential construction.  The most recent incident of such failure occurred on July 17, 2018. There were no frequent and regular inspections being performed by a competent person in that:  (a) employees were performing work from a ladder jack without utilizing a fall protection system and exposed to fall heights greater than 11 feet above the concrete surface below   (b) employees were using a portable extension ladder, for both access and siding work, that was positioned at a 50 degree angle and was not secured to prevent accidental displacement (due to the ladder angle)  (c) the area around the base of the access ladder was obstructed with siding, lumber and an air hose   (d) employees were not provided with falling object protection in that the garage entrance (where the foreman was cutting siding) was located immediately below the ladder jack platform where employees were installing siding  (e) fall protection harnesses, lanyards and anchors were not available on-site for employee use    Samuel and Maria Llano Falcon Construction was previously cited for a violation of this occupational safety and health standard or its equivalent standard 29 CFR 1926.20(b)(2), which was contained in OSHA inspection number 1258843, citation number 1, item number 1 and was affirmed as a final order on 1/04/2018, with respect to a workplace located at  4222 Mount Carmel Tabasco Rd., Cincinnati OH 45255.
Recent events (1)
  • — Z (R) $8536

1926.501 B13

Repeat Gravity 10 1 instance 1 exposed
Issued
Nov 14, 2018
Abate by
Dec 11, 2018
Penalty
Initial $8,536 · Current $8,536
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.  The employer fails to provide fall protection for employees engaged in residential construction.  The most recent incident of such failure occurred on July 17, 2018. Located on the northwest side of a residential structure, employees were performing siding work without using a fall protection system and exposed to fall heights greater than 11 feet above the ground below.  Samuel and Maria Llano Falcon Construction was previously cited for a violation of this occupational safety and health standard or its equivalent standard 29 CFR 1926.501(b)(13), which was contained in OSHA inspection number 1258843, citation number 1, item number 2 and was affirmed as a final order on 1/04/2018, with respect to a workplace located at  4222 Mount Carmel Tabasco Rd., Cincinnati OH 45255.
Recent events (1)
  • — Z (R) $8536

1926.503 A01

Repeat Gravity 10 1 instance 1 exposed
Issued
Nov 14, 2018
Abate by
Dec 11, 2018
Penalty
Initial $8,536 · Current $8,536
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.  The employer fails to provide fall protection for employees engaged in residential construction. The most recent incident of such failure occurred on or about July 17, 2018.The employer did not provide a training program for employees that were performing work from a ladder jack while not utilizing a fall protection system and exposed to fall heights greater than 11 feet above the concrete surface below.  Samuel and Maria Llano Falcon Construction was previously cited for a violation of this occupational safety and health standard or its equivalent standard 29 CFR 1926.503(a)(1), which was contained in OSHA inspection number 1258843, citation number 1, item number 3 and was affirmed as a final order on 1/04/2018, with respect to a workplace located at  4222 Mount Carmel Tabasco Rd., Cincinnati OH 45255.
Recent events (1)
  • — Z (R) $8536

View Samuel and Maria Llano Falcon Construction's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343304721.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.