DAYTON, OH —
OSHA Inspection: SABINO CORPUS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of SABINO CORPUS in 2516 MIAMISBURG CENTERVILLE RD, DAYTON, OH 45459 (NAICS 238130). OSHA activity number 343384707.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- SABINO CORPUS
- Site address
- 2516 MIAMISBURG CENTERVILLE RD
- City
- DAYTON
- State
- OH
- ZIP
- 45459
- Mailing
- 53 IRWIN ST NW, CARTERSVILLE, GA 30120
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 3
- Ownership type
- A
Citations
2 citations on file for this inspection.
1926.20 B02
- Issued
- Nov 30, 2018
- Abate by
- Dec 27, 2018
- Penalty
- Initial $3,880 · Current $3,880
General-duty citation text
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers. On or about the time period of July 24 - Aug. 14, 2018, there were no frequent and regular inspections being performed by a competent person in that: (a) employees were using a 3-prong orange extension cord with the ground wire pulled out of the outer jacket and had been cut off, effectively disabling the ground wire of the extension cord (b) employees were using a 3-prong orange extension cord that contained a 2 inch section that had been repaired with electrical tape (c) employees were using three extension cords with damaged outer jackets at three female ends, exposing the conductors and insulation inside the cord jacket (d) an employee was working from a JLG M600JP telescopic boom lift at fall heights greater than 15 feet above the concrete surface below without a fall protection system
Recent events (1)
- — Z (S) $3880
1926.453 B02 V
- Issued
- Nov 30, 2018
- Penalty
- Initial $3,880 · Current $3,880
General-duty citation text
29 CFR 1926.453(b)(2)(v): A body belt shall be worn and a lanyard attached to the boom or basket when working from an aerial lift. Note to paragraph (b)(2)(v): As of January 1, 1998, subpart M of this part (1926.502(d)) provides that body belts are not acceptable as part of a personal fall arrest system. The use of a body belt in a tethering system or in a restraint system is acceptable and is regulated under 1926.502(e). On Aug. 14, 2018, located on the north side of a commercial structure, an employee was observed working from a JLG M600JP extendable boom lift without being attached to the boom or basket. Potential fall heights were measured to be greater than 15 feet above the concrete surface below.
Recent events (1)
- — Z (S) $3880
More inspections in this industry (NAICS 238130)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343384707.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.