Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: JOSE ORTEGA

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JOSE ORTEGA in 325 E MAIN STREET, HORTONVILLE, WI 54944 (NAICS 238140). OSHA activity number 343643748.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Jose Ortega — free Get an email when a new federal OSHA severe-injury report for Jose Ortega is published. One employer, no account, unsubscribe in one click.
Establishment
JOSE ORTEGA
Site address
325 E MAIN STREET
City
HORTONVILLE
State
WI
ZIP
54944
Mailing
11116 BASELINE ROAD, LITTLE ROCK, AR 72209
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
3
Ownership type
A

5 citations on file for this inspection.

1926.20 B02

Deleted Serious Gravity 10 1 instance 3 exposed
Issued
Jan 17, 2019
Penalty
Initial $3,880 · Current $0 Reduced
29 CFR 1926.20(b)(2): It shall be the responsibility of the employer to initiate and maintain such programs as may be necessary to comply with this part; such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  On December 6, 2018 at 325 E Main Street in Hortonville, the employer did not ensure that a competent person was performing frequent and regular inspections that could have recognized the fall from elevation hazards associated with employees working from scaffold platforms without utilizing a complete fall protection system and standing on materials to extend reach from the scaffold platform.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3880

1926.451 F14

Deleted Serious Gravity 10 1 instance 1 exposed
Issued
Jan 17, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.451(f)(14): Makeshift devices, such as but not limited to boxes and barrels, shall not be used on top of scaffold platforms to increase the working level height of employees.  On December 6, 2018 at 325 E Main Street in Hortonville, an employee was standing on a twenty inch high bundle of foam board which was positioned on a scaffold platform nineteen and one half feet above surface level.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.451 G04 I

Deleted Serious Gravity 5 1 instance 2 exposed
Issued
Jan 17, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.451(g)(4)(i): Guardrail systems shall be installed along all open sides and ends of platforms. Guardrail systems shall be installed before the scaffold is released for use by employees other than erection/dismantling crews.  a)  On December 6, 2018 at 325 E Main Street in Hortonville, employees were working from a scaffold platform nineteen and one half feet above surface level without a complete fall protection system installed; end guards and mid-rails had not been installed.  b) On December 6, 2018 at 325 E Main Street in Hortonville, an employee was working from a scaffold platform thirteen feet above surface level without a complete fall protection system installed; end guards and mid-rails had not been installed.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.454 A01

Deleted Serious Gravity 5 1 instance 3 exposed
Issued
Jan 17, 2019
Penalty
Initial $2,772 · Current $0 Reduced
29 CFR 1926.454(a)(1): The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards including the nature of any electrical hazards, fall hazards and falling object hazards in the work area.  On December 6, 2018 at 325 E Main Street in Hortonville, the employer did not provide required scaffold safety training for employees who did not associate fall from elevation hazards when working from scaffold platforms without end guards and mid-rails installed.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2772

1926.454 B02

Deleted Serious Gravity 5 1 instance 3 exposed
Issued
Jan 17, 2019
Penalty
Initial $0 · Current $0
29 CFR 1926.454(b)(2): The employer shall have each employee who is involved in erecting, disassembling, moving, operating, repairing, maintaining, or inspecting a scaffold trained by a competent person to recognize any hazards associated with the work in question including the correct procedures for erecting, disassembling, moving, operating, repairing, inspecting, and maintaining the type of scaffold in question.  On or about December 6, 2018 at 325 E Main Street in Hortonville, the employer did not provide required scaffold assembly/disassembly safety training for employees who did not associate fall from elevation hazards during scaffold assembly with three platform levels without a fall protection system on any level.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View Jose Ortega's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343643748.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.