Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: SMITH & SONS HOME IMPROVEMENTS

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SMITH & SONS HOME IMPROVEMENTS in 18 E GLENWOOD AVE, SPRINGFIELD, OH 45506 (NAICS 238160). OSHA activity number 343653564.

Watch Smith & Sons Home Improvements — free Get an email when a new federal OSHA severe-injury report for Smith & Sons Home Improvements is published. One employer, no account, unsubscribe in one click.
Site address
18 E GLENWOOD AVE
City
SPRINGFIELD
State
OH
ZIP
45506
Mailing
5190 EASTLAND DR, NEW CARLISLE, OH 45344
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
2
Ownership type
A

3 citations on file for this inspection.

1926.20 B02

Serious Gravity 10 4 instances 2 exposed
Issued
Abate by
Penalty
Initial $3880.00 · Current $3880.00
29 CFR 1926.20(b)(2): Such programs shall provide for frequent and regular inspections of the job sites, materials, and equipment to be made by competent persons designated by the employers.  On Dec. 11, 2018, there were no frequent and regular inspections being performed by a competent person in that:  (a) employees were utilizing a portable extension ladder on a windy day, to access the second story roof from the porch roof, that had not been secured to the structure and was subsequently blown off the porch roof by a gust of wind  (b) employees were 'leapfrogging' the only portable extension ladder on-site on a windy day, pulling up the ladder to the porch roof and then ascending to the next roof line without properly securing the ladder to the structure   (c) employees were working on a low-slope pitch residential roof at fall heights greater than 19 feet above the ground below without a fall protection system  (d) employees performing roof felting operations did not have fall protection gear on-site before work began at the jobsite
Recent events (1)
  • — Z (S) $3880

1926.501 B01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3880.00 · Current $3880.00
29 CFR 1926.501(b)(1): "Unprotected sides and edges." Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems.  On Dec. 11, 2018, located throughout a residential roof, employees were performing roofing felt operations on a low-slope pitch roof with unprotected sides and edges while not utilizing a fall protection system. Potential fall heights were measured to be greater than 19 feet above the ground below.
Recent events (1)
  • — Z (S) $3880

1926.503 A01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $3880.00 · Current $3880.00
29 CFR 1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.  The employer did not provide a training program for employees performing roof felting operations on a low-slope pitch residential roof while not utilizing a fall protection system and exposed to fall heights greater than 19 feet above the ground below.
Recent events (1)
  • — Z (S) $3880

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343653564.